am42bds6408h Meet Spansion Inc., am42bds6408h Datasheet - Page 44

• Manufacturer Part Number: am42bds6408h
• Description: Cmos 1.8 Volt-only Simultaneous Read/write, Burst Mode Flash Memory, And 8 Mbit 512 K X 16-bit Sram
• Manufacturer: Meet Spansion Inc.

14. The system may read and program in non-erasing sectors, or
15. The Erase Resume command is valid only during the Erase
16. See “Set Configuration Register Command Sequence” for details.
17. Command is valid when device is ready to read array data or
18. The Reset command returns the device to reading the array.
19. Regardless of CLK and AVD# interaction or Control Register bit
20. ACC must be at V
42
enter the autoselect mode, when in the Erase Suspend mode.
The Erase Suspend command is valid only during a sector erase
operation, and requires the bank address.
Suspend mode, and requires the bank address.
when device is in autoselect mode.
15 setting, command mode verifies are always asynchronous
read operations.
HH
during the entire operation of this command
A D V A N C E
Am42BDS6408H
I N F O R M A T I O N
21. The fourth cycle programs the addressed locking bit. The fifth and
22. The fourth cycle erases all PPBs. The fifth and sixth cycles are
23. The entire four bus-cycle sequence must be entered for each
24. Before issuing the erase command, all PPBs should be
25. In the fourth cycle, 01h indicates PPB set; 00h indicates PPB not
sixth cycles are used to validate whether the bit has been fully
programmed. If DQ0 (in the sixth cycle) reads 0, the program
command must be issued and verified again.
used to validate whether the bits have been fully erased. If DQ0
(in the sixth cycle) reads 1, the erase command must be issued
and verified again.
portion of the password.
programmed in order to prevent over-erasure of PPBs.
set.
October 23, 2003