MC68HC908GR8CD Freescale Semiconductor, MC68HC908GR8CD Datasheet - Page 196

• Manufacturer Part Number: MC68HC908GR8CD
• Description: 8-bit Microcontrollers - MCU 8 Bit 8MHz
• Manufacturer: Freescale Semiconductor

Specifications of MC68HC908GR8CD

• Product Category: 8-bit Microcontrollers - MCU
• Rohs: yes
• Core: HC08
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 384 B
• Operating Supply Voltage: 3 V to 5 V
• Package / Case: SOIC-28
• Mounting Style: SMD/SMT
• Data Rom Size: 64 KB
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 21
• Program Memory Type: Flash

System Integration Module (SIM)
19.5.1.1 Hardware Interrupts
A hardware interrupt does not stop the current instruction. Processing of a hardware interrupt begins after
completion of the current instruction. When the current instruction is complete, the SIM checks all pending
hardware interrupts. If interrupts are not masked (I bit clear in the condition code register) and if the
corresponding interrupt enable bit is set, the SIM proceeds with interrupt processing; otherwise, the next
instruction is fetched and executed.
If more than one interrupt is pending at the end of an instruction execution, the highest priority interrupt is
serviced first.
is pending upon exit from the original interrupt service routine, the pending interrupt is serviced before the
LDA instruction is executed.
The LDA opcode is prefetched by both the INT1 and INT2 RTI instructions. However, in the case of the
INT1 RTI prefetch, this is a redundant operation.
19.5.1.2 SWI Instruction
The SWI instruction is a non-maskable instruction that causes an interrupt regardless of the state of the
interrupt mask (I bit) in the condition code register.
196
Figure 19-11
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
INT1
INT2
demonstrates what happens when two interrupts are pending. If an interrupt
Figure 19-11
MC68HC908GR8 • MC68HC908GR4 Data Sheet, Rev. 7
CLI
LDA
PSHH
PULH
RTI
PSHH
PULH
RTI
#$FF
.
Interrupt Recognition Example
NOTE
NOTE
INT1 INTERRUPT SERVICE ROUTINE
INT2 INTERRUPT SERVICE ROUTINE
BACKGROUND
ROUTINE
Freescale Semiconductor