NAND01GW3B2CN6E NUMONYX, NAND01GW3B2CN6E Datasheet - Page 21
![no-image](/images/manufacturer_photos/0/4/484/numonyx_sml.jpg)
NAND01GW3B2CN6E
Manufacturer Part Number
NAND01GW3B2CN6E
Description
IC FLASH 1GBIT 48TSOP
Manufacturer
NUMONYX
Specifications of NAND01GW3B2CN6E
Format - Memory
FLASH
Memory Type
FLASH - Nand
Memory Size
1G (128M x 8)
Interface
Parallel
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
48-TSOP
Cell Type
NAND
Density
1Gb
Access Time (max)
25us
Interface Type
Parallel
Boot Type
Not Required
Address Bus
8b
Operating Supply Voltage (typ)
3.3V
Operating Temp Range
-40C to 85C
Package Type
TSOP
Program/erase Volt (typ)
2.7 to 3.6V
Sync/async
Asynchronous
Operating Temperature Classification
Industrial
Operating Supply Voltage (min)
2.7V
Operating Supply Voltage (max)
3.6V
Word Size
8b
Number Of Words
128M
Supply Current
30mA
Mounting
Surface Mount
Pin Count
48
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Speed
-
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
NAND01GW3B2CN6E
Manufacturer:
Numonyx
Quantity:
5
Part Number:
NAND01GW3B2CN6E
Manufacturer:
ST
Quantity:
20 000
NAND01G-B2C
6
6.1
6.1.1
6.1.2
Device operations
The following section gives the details of the device operations.
Read memory array
At power-up the device defaults to read mode. To enter read mode from another mode the
Read command must be issued, see
Once a Read command is issued two types of operations are available: random read and
page read.
Random read
Each time the Read command is issued the first read is random read.
Page read
After the first random read access, the page data (2112 bytes or 1056 words) is transferred
to the page buffer in a time of t
complete the Ready/Busy signal goes High. The data can then be read out sequentially
(from selected column address to last column address) by pulsing the Read Enable signal.
Alternatively, the user may check the transfer completion by issuing the Read Status
Register command and checking SR6 by toggling R. In the latter case, the device will keep
on outputting the read status register until the 00h command is issued.
The device can output random data in a page, instead of the consecutive sequential data, by
issuing a Random Data Output command.
The Random Data Output command can be used to skip some data during a sequential
data output.
The sequential operation can be resumed by changing the column address of the next data
to be output, to the address which follows the Random Data Output command.
The Random Data Output command can be issued as many times as required within a
page.
The Random Data Output command is not accepted during cache read operations.
WHBH
(refer to
Table 10:
Table 25
Commands.
for value). Once the transfer is
Device operations
21/67