INDART-ONE/FSL SofTec Microsystems SRL, INDART-ONE/FSL Datasheet - Page 132

• Manufacturer Part Number: INDART-ONE/FSL
• Description: PROG/DEBUG FOR HC08/HCS08/HCS12
• Manufacturer: SofTec Microsystems SRL
• Series: inDARTr
• Type: In-Circuit, Real-Time Debugger/Programmerr

Specifications of INDART-ONE/FSL

• Contents: In-circuit debugger/programmer unit, Cables, Evaluation Board and Software
• For Use With/related Products: Freescale HC08/S08/RS08/S12/S12X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 520-1038; INDART-ONE

10
2.
3.
10.1.3 CodeWarrior-Specific: Stepping Execution is Slow
When the “Memory” window is open, step commands may execute slower,
since the “Memory” window contents need to be refreshed after every step.
10.1.4 HC08-Specific: Peripheral Speed is Low
The “Frequency divider” parameter (in the “Communication Settings”
dialog box) should always be set to 4 in order to guarantee that, in monitor
mode, all of the target microcontroller’s peripherals run at the same speed
they do in user mode. If, however, you set this parameter to 2 not all
peripherals will work at this doubled speed.
130
Make sure that the target board is powered on and the target
microcontroller is working. Programming and debugging rely on a
MON08/BDM communication between inDART-One and the target
board. This means that, in order to work correctly, the target
microcontroller must be running. In particular, make sure that:
Make sure you are working with the correct inDART hardware model.
a)
b)
c)
The MON08/BDM cable is connected to the target board.
All of the required MON08/BDM connector signals are correctly
tied to the target microcontroller.
To view/change the inDART hardware model in use in
CodeWarrior, choose “Connect” (or “Communication”) from the
“inDART-HC08”, “SofTec-HCS08”, “SofTec-RS08” or “inDART-
HCS12” menu (depending on the target device currently selected)
in the CodeWarrior debugger window.
To view/change the inDART hardware model in the DataBlaze
programming utility, select the “Operations > Select Device”
menu item.
To view/change inDART-One instruments in the MultiBlaze gang
programming utility, choose the “New Project” or “Modify
Project” options.
inDART-One User's Manual