INDART-ONE/FSL SofTec Microsystems SRL, INDART-ONE/FSL Datasheet - Page 93

• Manufacturer Part Number: INDART-ONE/FSL
• Description: PROG/DEBUG FOR HC08/HCS08/HCS12
• Manufacturer: SofTec Microsystems SRL
• Series: inDARTr
• Type: In-Circuit, Real-Time Debugger/Programmerr

Specifications of INDART-ONE/FSL

• Contents: In-circuit debugger/programmer unit, Cables, Evaluation Board and Software
• For Use With/related Products: Freescale HC08/S08/RS08/S12/S12X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 520-1038; INDART-ONE

The “RESET Rise Time” parameter specifies the time, in milliseconds,
needed for the target RESET signal to go high. This value depends on the
target system, and is used by inDART-One to generate the appropriate delay
before to drive the BKGD line correctly in order to enter the special single
chip mode. The default value of 20 ms is appropriate for most systems.
i
Note: only the central pin of the “TARGET POWER OUT”
connector is used, while the outer sleeve is not connected.
The GND reference is taken from the “BDM” cable.
inDART-One User's Manual
91
8