INDART-ONE/FSL SofTec Microsystems SRL, INDART-ONE/FSL Datasheet - Page 58

• Manufacturer Part Number: INDART-ONE/FSL
• Description: PROG/DEBUG FOR HC08/HCS08/HCS12
• Manufacturer: SofTec Microsystems SRL
• Series: inDARTr
• Type: In-Circuit, Real-Time Debugger/Programmerr

Specifications of INDART-ONE/FSL

• Contents: In-circuit debugger/programmer unit, Cables, Evaluation Board and Software
• For Use With/related Products: Freescale HC08/S08/RS08/S12/S12X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 520-1038; INDART-ONE

Working with HC08 Devices
Communication settings are defined through the “Communication Settings”
dialog box, available both in CodeWarrior and in the DataBlaze and
MultiBlaze programming utilities.
The dialog box is divided into four sections: “MON08 Configuration”, “Power
Settings”, “Programming” and “Trimming”. All of the parameters must be
carefully set, otherwise unsuccessful operations will result.
5.2.1 MON08 Configuration
This section shows you what lines of the target microcontroller must be tied
to the MON4-MON8 lines of the MON08 connector. Depending on the
microcontroller, either the MON4 or MON5 line is dedicated to the single-
wire communication (which is reserved during debugging).
The other MON lines must be driven at specific values at reset. inDART-One
automatically drives all of the required lines upon reset, and releases them
soon afterwards (except for the single-wire communication line which is
always reserved). Please note that each microcontroller implements the
5
MON08 interface on different ports and pins.
Figure 5.1: MON08 Communication Settings: MON08 Configuration
56