STEVAL-IFS001V1 STMicroelectronics, STEVAL-IFS001V1 Datasheet - Page 34

• Manufacturer Part Number: STEVAL-IFS001V1
• Description: EVAL BOARD 3AXIS MEMS ACCELLRMTR
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-IFS001V1

• Design Resources: STEVAL-IFS001V1 Gerber Files STEVAL-IFS001V1 Schematic STEVAL-IFS001V1 Bill of Material
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g, 6g
• Interface: I²C, SPI
• Sensitivity: 1024 LSb/g
• Voltage - Supply: 2.16 V ~ 3.6 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LIS3LV02DQ
• Processor To Be Evaluated: LIS3LV02DQ
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-5069

7 Register Description
7.25
34/42
DD_CFG (38h)
Direction-detector configuration register
IEND
LIR
ZHIE
ZLIE
YHIE
YLIE
XHIE
XLIE
Interrupt enable on Direction change. Default value: 0
(0: disabled;
1: interrupt signal enabled)
Latch Interrupt request into DD_SRC reg with the DD_SRC reg cleared by reading
DD_ACK reg. Default value: 0.
(0: interrupt request not latched;
1: interrupt request latched)
Enable interrupt generation on Z high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Z low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on Y high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Y low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on X high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on X low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
IEND
LIR
ZHIE
CD00047926
ZLIE
YHIE
YLIE
XHIE
XLIE
LIS3LV02DQ