NP8P128A13BSM60E Micron Technology Inc, NP8P128A13BSM60E Datasheet - Page 29

• Manufacturer Part Number: NP8P128A13BSM60E
• Manufacturer: Micron Technology Inc

Specifications of NP8P128A13BSM60E

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Numonyx® Omneo™ P8P Datasheet
9.3
August 2010
316144-07
During a suspend, CE# = V
current. V
in suspend mode.
The Resume (D0h) command instructs the WSM to continue writing/erasing and
automatically clears Status Register bits SR.2 (or SR.6) and SR.7. If Status Register
error bits are set, the Status Register can be cleared before issuing the next
instruction. RST# must remain at V
Flowchart” on page 74
page
If software compatibility with the Numonyx™ P33 device is desired, a minimum
time
between an Erase command and a subsequent Erase Suspend command to ensure that
the device achieves sufficient cumulative erase time. Occasional Erase-to-Suspend
interrupts do not cause problems, but out-of-spec Erase-to-Suspend commands issued
too frequently to a P33 device may produce uncertain results. However, this
specification is not required for this PCM device.
Erase Resume
The Erase Resume command instructs the device to continue erasing, and
automatically clears status register bits SR[7,6]. This command can be written to any
address. If status register error bits are set, the Status Register should be cleared
before issuing the next instruction. RST# must remain deasserted (see
“Write Suspend/Resume Flowchart” on page
(See
77.
Section 17.0, “Program and Erase Characteristics” on page 71
PP
must remain at its program level and WP# must remain unchanged while
and
IH
Section 34, “Erase Suspend/Resume Flowchart” on
places the device in standby state, which reduces supply
IH
. See
Section 31, “Write Suspend/Resume
74).
)
Figure 31,
should elapse
t
ERS/SUSP
29