DP83849CVS/NOPB National Semiconductor, DP83849CVS/NOPB Datasheet - Page 64

• Manufacturer Part Number: DP83849CVS/NOPB
• Description: IC TXRX ETHERNET PHY DUAL 80TQFP
• Manufacturer: National Semiconductor
• Type: Transceiverr

Specifications of DP83849CVS/NOPB

• Number Of Drivers/receivers: 2/2
• Protocol: Ethernet
• Voltage - Supply: 3 V ~ 3.6 V
• Mounting Type: Surface Mount
• Package / Case: 80-TQFP, 80-VQFP
• Data Rate: 100Mbps
• Supply Voltage Range: 3V To 3.6V
• Logic Case Style: TQFP
• No. Of Pins: 80
• Operating Temperature Range: 0°C To +70°C
• Msl: MSL 3 - 168 Hours
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Data Rate Max: 10Mbps
• For Use With: DP83849CVS-EVK - BOARD EVALUATION DP83849CVS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *DP83849CVS; *DP83849CVS/NOPB; DP83849CVS

www.national.com
Bit
6
5
4
3
2
1
0
JABBER DETECT
AUTO-NEG COM-
DUPLEX STATUS
LOOPBACK STA-
REMOTE FAULT
SPEED STATUS
LINK STATUS
Bit Name
PLETE
TUS
Table 29. PHY Status Register (PHYSTS), address 10h
Default
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
0, RO
Remote Fault:
1 = Remote Fault condition detected (cleared on read of BMSR (ad-
dress 01h) register or by reset). Fault criteria: notification from Link
Partner of Remote Fault via Auto-Negotiation.
0 = No remote fault condition detected.
Jabber Detect: This bit only has meaning in 10 Mb/s mode
This bit is a duplicate of the Jabber Detect bit in the BMSR register,
except that it is not cleared upon a read of the PHYSTS register.
1 = Jabber condition detected.
0 = No Jabber.
Auto-Negotiation Complete:
1 = Auto-Negotiation complete.
0 = Auto-Negotiation not complete.
Loopback:
1 = Loopback enabled.
0 = Normal operation.
Duplex:
This bit indicates duplex status and is determined from Auto-Nego-
tiation or Forced Modes.
1 = Full duplex mode.
0 = Half duplex mode.
Note: This bit is only valid if Auto-Negotiation is enabled and com-
plete and there is a valid link or if Auto-Negotiation is disabled and
there is a valid link.
Speed10:
This bit indicates the status of the speed and is determined from
Auto-Negotiation or Forced Modes.
1 = 10 Mb/s mode.
0 = 100 Mb/s mode.
Note: This bit is only valid if Auto-Negotiation is enabled and com-
plete and there is a valid link or if Auto-Negotiation is disabled and
there is a valid link.
Link Status:
This bit is a duplicate of the Link Status bit in the BMSR register,
except that it will not be cleared upon a read of the PHYSTS regis-
ter.
1 = Valid link established (for either 10 or 100 Mb/s operation)
0 = Link not established.
64
Description