UPD78F9222MC(T)-5A4-A NEC, UPD78F9222MC(T)-5A4-A Datasheet - Page 299

• Manufacturer Part Number: UPD78F9222MC(T)-5A4-A
• Description: 8BIT MCU, 4K FLASH, 256B RAM, 78F9222
• Manufacturer: NEC

Specifications of UPD78F9222MC(T)-5A4-A

• Controller Family/series: UPD78
• No. Of I/o's: 17
• Ram Memory Size: 256Byte
• Cpu Speed: 10MHz
• No. Of Timers: 4
• No. Of: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 4KB
• Oscillator Type: External, Internal

18.8.8 Example of byte write operation in self programming mode
An example of the byte write operation in self programming mode is explained below.
<1> Set 05H (byte write) to the flash program command register (FLCMD).
<2> Set the number of block to which data is to be written, to flash address pointer H (FLAPH).
<3> Set the address at which data is to be written, to flash address pointer L (FLAPL).
<4> Set the data to be written, to the flash write buffer register (FLW).
<5> Clear the flash status register (PFS).
<6> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<8> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
<9> Byte write processing is abnormally terminated.
<10> Byte write processing is normally terminated.
Note This setting is not required when the watchdog timer is not used.
Caution If a write results in failure, erase the block once and write to it again.
<7> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
Abnormal → <9>
Normal
HALT instruction if self programming has been executed.)
→ <10>
CHAPTER 18 FLASH MEMORY
User’s Manual U16898EJ5V0UD
Note
299
.