CV500BC051 Omron, CV500BC051 Datasheet - Page 100

• Manufacturer Part Number: CV500BC051
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BC051

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Wiring
5. Move the cable connector so that the loose ends are on the left-hand side,
Even in token-ring mode, the network will be broken and communications may
be disrupted if disconnections occur at two or more places. Be sure not to
allow connectors to be disconnected during communications.
Example: Connections for Duplex Operation of Communications Units
• Insert the connectors completely and always check that the connectors
• Do not pull on the Optical Fiber Cable too forcefully.
• Do not bend the cable too sharply. The minimum radius for bends is
• To prevent the Optical Fiber Cable from being pulled too forcefully, always
• Do not place objects on top of the Optical Fiber Cable. The maximum
• Inspect the connector before installing it.
and insert the Unit’s optical connector as far as it will reach.
are locked before starting operation.
The maximum tension that can be applied to the cord is 10 kg and the
maximum tension that can be applied to the cable is 50 kg.
10 cm.
use the cable securing bracket and provide space below the Unit as
shown in the following diagram. Do not exceed the maximum tension for
the cord and cable:
pressure that can be placed on the cord and cable is as follows:
Terminal
Mounting bracket
Cord:
Cable: 5 kg
Cord:
Cable: 50 kg/10 cm
0 kg (Do not apply any tension.)
30 kg/10 cm
ON
SW1
1
2
BD H
BD L
SHLD
BAUD
RATE
CS1W -RPT 02
+
−
Tension member
PWR
T/R1
T/R2
TER SW
DC24 V
INPUT
SL1
SL2
ON
Cord
Cord
Cable
Cable
Section 3-3
75