CV500BC051 Omron, CV500BC051 Datasheet - Page 68

• Manufacturer Part Number: CV500BC051
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BC051

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Message Service Procedure
6. Set the data link mode.
7. Create the user program.
Note When using fewer than 33 nodes, make sure that the Wired Network
Enable 62 nodes for a
wired network.
a. Prepare the send and receive
b. Prepare the control data for the
c. Check the conditions for exe-
d. Execute the SEND/RECV or
e. Execute other instructions are
data in memory.
communications instruction.
cuting the SEND/RECV or
CMND instruction.
CMND instruction.
required for the results of the
communications instruction,
(e.g., retry or error processing
if an error occurs).
62 Node Enable Bit in the DM Parameter Area software switches is
turned OFF to restrict the network to 32 nodes maximum. To con-
struct a network containing more than 32 nodes, all nodes must use
the CS1W-CLK21-V1, CS1W-CLK23, CJ1W-CLK21-V1, or CJ1W-
CLK23.
Contents
Contents
Use Support Soft-
ware for the PLC or a
Programming Con-
sole.
Method
Stored in the memory areas of the
source node
The standard input conditions are
the Active Node Flags for the
source and destination nodes, and
the Port Enabled Flag.
---
The standard input condition is the
Port Error Flags.
C200HX/HG/HE PLCs have 1
communications port for each
operating level. When 2 or more
communications instructions are
executed at the same time, exclu-
sive control is necessary.
CS-series, CJ-series, CVM1, and
CV-series PLCs have 8 communi-
cations ports. When 9 or more
communications instructions are
executed at the same time, exclu-
sive control is necessary.
CQM1H-series PLCs have only 1
communications port. When 2 or
more communications instructions
are executed at the same time,
exclusive control is necessary.
All nodes
This setting must be
made when construct-
ing a network that
uses a node address
higher than 32 (See
note.)
Remarks
Nodes
Section 2-2
80
168
192
Page
Page
43