CV500BC051 Omron, CV500BC051 Datasheet - Page 158

• Manufacturer Part Number: CV500BC051
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500BC051

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Setting Data Links
Automatic Setting, 1:N
Allocations
Note
This method is used to simplify the establishment of 1:N allocation data links
between master and slave nodes.
1. Automatic data link creation with 1:N allocations can only be used with the
2. Controller Link Units and Support Boards other than those listed above
3. For automatic data link creation with 1:N allocations, use the CX-Net in CX-
• There are three types of 1:N allocations.
• Programming Devices (including Programming Consoles) are used to set
• Node 1 is the master node.
• Area 1 can be set in the bit-access areas and area 2 can be set in the DM
• The send area sizes of the master and slave nodes are the same for each
• Send nodes are in the same ascending order as node numbers.
• All nodes can be specified to either participate or not participate in the
• The data link areas (data link start words) are common to all nodes partic-
the automatic data link mode in the DM Parameter Area of the PLC used
as the startup node.
Area.
area.
data link.
ipating in the data links.
following Controller Link Units and Support Boards:
cannot participate in 1:N allocation data links. They can, however, join the
network if a parameter in the DM Parameter Area is set so that they do not
participate in the data links.
Programmer version 3.2 or higher.
Wired networks
Area 1
Area 2
Type
Node 1
1
2
3
4
1
2
3
4
CS1W-CLK21-V1 and CS1W-CLK23 (for CS Series)
CJ1W-CLK21-V1 and CJ1W-CLK23 (for CJ Series)
3G8F7-CLK21-V1 and 3G8F7-CLK23-E (for PCI bus)
Node 2
1
2
1
2
Node 3
1
3
1
3
Model
Node 4
1
4
1
4
Section 5-2
133