NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 31

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2-2
2-2-1 Installation to the Operation Panel
Installation
Installation
Correct use
Reference
Caution
Caution
Install the NT30/30C to the operation panel and connect the power to the
NT30/30C as described below.
The NT30/30C is mounted on an operation panel by embedding it in the panel.
Use the panel fittings and tools included in the product package and follow the
procedure below.
If the DIP switch settings have been changed when the NT30/30C is powered,
reset the power to the NT30/30C. The changes with the DIP switches become
effective only after the power supply is reset. Before switching ON the power for
the first time, set DIP switch pin 6 of the NT30/30C to ON (they are set to OFF on
shipping). If they are left OFF, messages will not be displayed normally.
In addition to the DIP switch settings, set also the host communications, port,
baud rate, etc., in the memory switches. For these settings, refer to 3-5 Setting
the Conditions of Communications with the PC by Using the Memory Switches
(page 83).
S Do not install the NT30/30C at sites subject to the following conditions.
S Take adequate measures to ensure shielding if the NT30/30C is used at a
S During work at the panel, take care to ensure that no metal scraps enter the
S The thickness of applicable operation panel is 1.6 mm to 4.8 mm. All fittings
Otherwise, the product may malfunction.
- Severe temperature variations
- Temperatures or humidities outside the ranges stated in the specifications
- High humidity, condensation
- Splashing chemical agents
- Severe oil splashing
- Corrosive or flammable gases
- Strong vibrations or shocks
- Direct exposure to wind and rain (outdoor sites)
- Strong ultra-violet irradiation
location subject to any of the following conditions. Otherwise, the product may
malfunction.
- Static electricity, or noise from other equipment
- Strong electromagnetic fields
- Nearby power cables
- Potential exposure to radioactivity
Unit. Otherwise, the product may malfunction.
must be tightened uniformly to a torque of 0.5 to 0.6 N⋅m in order to ensure
water- and dust-resistance. The panel must not be soiled or warped, and must
be able to support an installation that will remain secure and strong.
Section
2-2
19