NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 88

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3-3-3 Operations with the System Menu
Displaying the System Menu
Selecting the Menu Items
Operation Modes and the System Menu
The following gives the procedure to call the System Menu, select the menu
items, and other operations with the System Menu.
Make sure that DIP switch SW2 pin 3 (Switch to the System Menu enabled/dis-
abled) is set to OFF (enabled). If the setting is ON (disabled), the System Menu
will not be displayed by following the procedure given below.
Press appropriate touch switches to display the System Menu as mentioned be-
low. The RUN indicator goes OFF when the System Menu is displayed.
The NT30/30C display screen has four touch switches to display the System
Menu in the four corners (about 7.2 mm x 7.2 mm size). Press any two of these
switches at the same time to call the System Menu screen.
Note that the touch switches used to call the System Menu are not displayed on
the screen. If a touch switch displayed in a corner is pressed first, the touch
switch will function and the System Menu will not be displayed. To successfully
call the System Menu, first press a corner where no touch key is displayed, and
then, press any other corner regardless of the presence of a touch key.
If a screen has the touch switches registered at all of the four corners, it is impos-
sible to call the System Menu from the screen.
A system function can be assigned to a touch switch. Pressing the touch switch
so assigned on the screen can easily display the System Menu. For the relation-
ship between the system key and the touch switch, refer to the System Key Func-
tions (page 159).
Press (touch) a menu item on the screen to select the item.
Menu items allow to make the ON/OFF selection or to call subsequent menu or
screen.
Example 1
To call the Maintenance Menu by pressing “Maintenance Mode” on the System
Menu screen:
[ SYSTEM MENU ]
POWER
Maintenance Mode
RUN
Transmit Mode
RUN mode
Quit
Press any two
of these four
corners at the
same time.
Select “Maintenance Mode.”
[SYSTEM MENU]
Transmit Mode
Maintenance Mode
Quit
Section
3-3
77