NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 35

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2-5
2-5-1 Compatible PCs
Connection to a PC by Host Link via RS-232C
Connection to a PC by Host Link via RS-232C
(2) Put the NT30/NT30C on Standby for Installation
(3) Transfer the System Program
S System Installer Settings
S Selecting the System Program to be Transferred
Connect the NT30/30C to an OMRON PC by using the RS-232C Host Link meth-
od.
In order to make a connection to the PC using the Host Link method via
RS-232C, the host communications memory switch of the NT30/30C must be set
to Host Link, and the port memory switch must be set to RS-232C. For details on
memory switch settings, see Selecting the Host Communication Method
(page 85) and Selecting the Host Link Communication Port (page 87).
Some models and series of OMRON PCs have the Host Link function built in.
With CS1-series and CQM1H PCs, Host Link communications are possible by
adding a Serial Communications Board. Also, there are some C200HX/HG/HE
CPU Units that support Host Link communications when a Communications
Board is mounted.
Check the model and series of the PC, and the model of Communications Board
mounted, before making connections.
The PCs that can be connected by Host Link via RS-232C are listed in the table
below.
In the System Installer settings, specify the type of PT to which the system pro-
gram is installed.
Specify either NT30 or NT30C as the PT model (with DOS versions, the setting
is as the NT-series model under the tool settings). Make other settings according
to the operating conditions of the System Installer.
Select the name of the desired system program from the communications meth-
ods displayed in the system program list in the System Installer.
For details, refer to the the manual provided with the System Installer.
Turn OFF the power supply and return DIP switch pin 7 that was turned ON
in step 1 to OFF. After that, turn ON the power supply again. The
NT30/NT30C will go into standby, waiting for system program installation.
Connect the NT30/NT30C to the computer, start up System Installer, and
transfer and install the system program.
For details of operation, refer to the manual provided with the System
Installer.
Section
2-5
23