NT30-KBA04 Omron, NT30-KBA04 Datasheet - Page 65

• Manufacturer Part Number: NT30-KBA04
• Description: ANTI GLARE COVER FOR NT31
• Manufacturer: Omron

Specifications of NT30-KBA04

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Connection to a PC by Host Link via RS-422A
C200HX/HG/HE(-Z)
CQM1H
CPM1
CPM2A, SRM1
CPM2C
PC
RS-422A
Reference
I/O port
selector
switch
RS-232C
*1
Setting the Front Switches
S C-series C200HX/HG/HE(-Z), CPM1, CPM2A, CPM2C, or CQM1H CPU
S There are no Communications Boards for C200HX/HG/HE(-Z) PCs for which
S There are no Serial Communications Boards for CQM1H PCs for which port 1
PC Setup Settings
Set the following communications settings in the PC Setup.
The method for connecting to the CPU Unit depends on the model of PC in the
way shown in the following table.
Unit, or SRM1
port B is the RS-422A port.
is the RS-422A port.
Baud rate
Stop bit
Parity
Data length
Unit #
Set the Host Link baud rate to 9,600 bps or 19,200 bps with the memory
switch for the baud rate. For details, refer to Selecting the Host Link Baud
Rate (page 86).
S Connect to the RS-422A port (port A) on the Communications Board.
S Connect to the RS-422A port (port 2) on the Serial Communications Board.
S Connect via the CPM1-CIF11 RS-422A Adapter using the peripheral port.
S Connect via the CPM1-CIF11 RS-422A Adapter using the peripheral port.
S Connect to the peripheral port using the CPM2C-CN111 or CS1W-CN114 Con-
necting Cable and the CPM1-CIF11 RS-422A Adapter. (The CPM2C-CN111
splits the communications port on the CPU Unit into an RS-232C port and the
peripheral port. The CPM1-CIF01 RS-232C Adapter is also required to connect
to the peripheral port.)
Item
S Host Link default value setting (DIP switch pin 4)
S Terminator setting (DIP switch pin 6)
S Host Link communications method (selector switch)
To effect the existing DIP switch settings, set pin 4 to ON.
To effect the existing PC Setup, set pin 4 to OFF.
Note: The existing DIP switch settings differ from the existing
When using an RS-422A cable, set pin 6 to ON.
(Set this for termination.)
Note: Set the Link Adapter to ON also.
- If connecting to an RS-232C connector, set this to RS-232C.
-
I
f connecting to an RS-422A connector, set this to RS-422A.
Set to the same baud rate as the NT30/NT30C (See note 1.)
2 stop bits
Even
ASCII 7 bits
00
PC Setup as follows.
- DIP switch settings: 2400 bps, 1 stop bit, even parity,
- PC Setup: 9,600 bps, 2 stop bits, even parity, 7-bit
7-bit data length
data length
Connection Method
Possible Settings
Section
2-6
53