VS6624Q0KP STMicroelectronics, VS6624Q0KP Datasheet - Page 15

• Manufacturer Part Number: VS6624Q0KP
• Description: Display Modules & Development Tools CAMERA MODULE SINGLE CHIP 1.3MEGA
• Manufacturer: STMicroelectronics

Specifications of VS6624Q0KP

• Description/function: Camera Module
• Interface Type: Two-Wire Serial
• Data Bus Width: 8 bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

VL6624/VS6624
Note:
4.1
Pause mode
are accessible but no data is output from the device. The device is ready to start streaming
but is halted. This mode is used to set up the required output format before outputting any
data.
The analogue video block is powered down, leading to a lower global consumption
The PowerManagement register can be adjusted in PAUSE mode but has no effect until the
next RUN to PAUSE transition.
Streaming modes
RUN mode
a continuous stream of images, according to the set image format parameters and frame
rate control parameters. The image size is derived through downscaling of the SXGA image
from the pixel array.
Snapshot mode
the size, format and reconstruction settings in the relevant pipe setup bank. In normal
operation this frame will be output, once the exposure, white balance and dark-cal systems
are stable. To reduce the latency to output, the user may manually override the stability
flags.
The snapshot mode command can be issued in either Run or Stop mode and the device will
automatically return previous state after the snapshot is taken. The snapshot mode must not
be entered into while viewlive is selected.
FLASHGUN mode
flashgun. A flash is triggered and a single frame of data is output and the device
automatically switches to Pause Mode.
VS6624 supports the following flashgun configurations:
●
●
ViewLive this feature allows different sizes, formats and reconstruction settings to be
applied to alternate frames of data, while in run mode.
Torch Mode - user can manually switch on/off the FSO IO pin via a register setting.
Independent of mode.
Pulsed Mode - the flash output is synchronized to the image stream. There are two
options available:
–
–
–
–
–
Pulsed flash with snapshot. Device outputs a single frame synchronized to flash.
Pulsed flash with viewfinder. Device outputs a flash pulse synchronized to a single
frame in the image stream.
In the pulsed mode there are two possible pulse configurations:
Single pulse during the interframe period when all image lines are exposed. This is
suitable for SCR and IGBT flash configurations. The falling edge of the pulse can
be programmed to vary the width of the pulse.
Single pulse over entire integration period of frame. This is suitable for LED flash
configurations.
In this mode all VL6624/VS6624 clocks are running and all registers
This is the fully operational mode. In running mode the device outputs
The device can be configured to output a single frame according to
In flashgun mode, the array is configured for use with an external
Operational modes
15/106