LAN9311I-NZW Standard Microsystems (SMSC), LAN9311I-NZW Datasheet - Page 115

• Manufacturer Part Number: LAN9311I-NZW
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9311I-NZW

• Number Of Primary Switch Ports: 2
• Internal Memory Buffer Size: 32
• Operating Supply Voltage (typ): 3.3V
• Fiber Support: No
• Integrated Led Drivers: Yes
• Phy/transceiver Interface: MII
• Power Supply Type: Analog
• Data Rate (typ): 10/100Mbps
• Vlan Support: Yes
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Pin Count: 128
• Mounting: Surface Mount
• Jtag Support: No
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Operating Temperature Classification: Industrial
• Data Rate: 100Mbps
• Lead Free Status / RoHS Status: Compliant

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
SMSC LAN9311/LAN9311i
9.4
Preamble
Preamble
7 Bytes
7 Bytes
should be unique. If both are set to the same value, VLAN1 is given higher precedence and the
maximum legal frame length is set to 1522.
The Ethernet address fields of an Ethernet packet consist of two 6-byte fields: one for the destination
address and one for the source address. The first bit of the destination address signifies whether it is
a physical address or a multicast address.
The Host MAC address check logic filters the frame based on the Ethernet receive filter mode that has
been enabled. The various filter modes of the Host MAC are specified based on the state of the control
bits in the
14.3.1, "Host MAC Control Register (HMAC_CR)," on page 272
If the frame fails the filter, the Host MAC does not receive the packet. The host has the option of
accepting or ignoring the packet.
Note: This filtering function is performed after any switch fabric filtering functions. The user must
Address Filtering
1 Byte
1 Byte
SOF
SOF
ensure the switch filtering is setup properly to allow packets to be passed to the Host MAC for
further filtering.
Host MAC Control Register
Dest. Addr.
Dest. Addr.
6 Bytes
6 Bytes
2 Bytes
TPID
Source Addr.
Source Addr.
6 Bytes
6 Bytes
Standard Ethernet Frame (1518 Bytes)
Figure 9.1 VLAN Frame
Tag Control Information
Ethernet Frame with VLAN TAG (1522 Bytes)
DATASHEET
2 Bytes
2 Bytes
Type
TPID
(HMAC_CR), as shown in
User Priority
(TCI)
115
3 Bits
2 Bytes
Type
Tag Protocol ID: \x81-00
46-1500 Bytes
1 Bit
CFI
2 Bytes
Type
Indicates the frame’s priority
Data
VLAN ID
Canonical Address Format Indicator
12 Bits
for more information on this register.
Table
46-1500 Bytes
9.1. Please refer to the
Data
Defines the VLAN to
which the frame belongs
4 Bytes
FCS
Revision 1.7 (06-29-10)
4 Bytes
FCS
Section