LAN9311I-NZW Standard Microsystems (SMSC), LAN9311I-NZW Datasheet - Page 412

• Manufacturer Part Number: LAN9311I-NZW
• Manufacturer: Standard Microsystems (SMSC)

Specifications of LAN9311I-NZW

• Number Of Primary Switch Ports: 2
• Internal Memory Buffer Size: 32
• Operating Supply Voltage (typ): 3.3V
• Fiber Support: No
• Integrated Led Drivers: Yes
• Phy/transceiver Interface: MII
• Power Supply Type: Analog
• Data Rate (typ): 10/100Mbps
• Vlan Support: Yes
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Pin Count: 128
• Mounting: Surface Mount
• Jtag Support: No
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Operating Temperature Classification: Industrial
• Data Rate: 100Mbps
• Lead Free Status / RoHS Status: Compliant

Revision 1.7 (06-29-10)
14.5.4
14.5.4.1
BITS
31:7
4:2
6
5
1
0
RESERVED
BM Counter Test
When this bit is set, Buffer Manager (BM) counters that normally clear to 0
when read, will be set to 7FFF_FFFC when read.
Fixed Priority Queue Servicing
When set, output queues are serviced with a fixed priority ordering. When
cleared, output queues are serviced with a weighted round robin ordering.
Egress Rate Enable
When set, egress rate pacing is enabled. Bits 4,3,2 correspond to switch
ports 2,1,0 respectively.
Drop on Yellow
When this bit is set, packets that exceed the Ingress Committed Burst Size
(colored Yellow) are subjected to random discard.
Note:
Drop on Red
When this bit is set, packets that exceed the Ingress Excess Burst Size
(colored Red) are discarded.
Note:
Buffer Manager CSRs
This section details the Buffer Manager (BM) registers. These registers allow configuration and
monitoring of the switch buffer levels and usage. A list of the general switch CSRs and their
corresponding register numbers is included in
Buffer Manager Configuration Register (BM_CFG)
This register enables egress rate pacing and ingress rate discarding.
See
Register (SWE_INGRSS_RATE_CMD)," on page 395
information on configuring the Ingress Committed Burst Size.
See
Register (SWE_INGRSS_RATE_CMD)," on page 395
information on configuring the Ingress Excess Burst Size.
Register #:
Section 14.5.3.26, "Switch Engine Ingress Rate Command
Section 14.5.3.26, "Switch Engine Ingress Rate Command
1C00h
DESCRIPTION
DATASHEET
412
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Table
Size:
14.12.
for
for
32 bits
TYPE
R/W
R/W
R/W
R/W
R/W
SMSC LAN9311/LAN9311i
RO
DEFAULT
Datasheet
0b
0b
0b
0b
0b
-