FDC37M817-MS Standard Microsystems (SMSC), FDC37M817-MS Datasheet - Page 70

• Manufacturer Part Number: FDC37M817-MS
• Manufacturer: Standard Microsystems (SMSC)

Specifications of FDC37M817-MS

• Pin Count: 100
• Lead Free Status / RoHS Status: Compliant

Bit 1
Setting this bit to a logic "1" clears all bytes in the
RCVR FIFO and resets its counter logic to 0. The
shift register is not cleared.
clearing.
Bit 2
Setting this bit to a logic "1" clears all bytes in the
XMIT FIFO and resets its counter logic to 0. The
shift register is not cleared.
clearing.
Bit 3
Writing to this bit has no effect on the operation of
the UART. The RXRDY and TXRDY pins are not
available on this chip.
Bit 4,5
Reserved
Bit 6,7
These bits are used to set the trigger level for the
RCVR FIFO interrupt.
INTERRUPT IDENTIFICATION REGISTER (IIR)
Address Offset = 2H, DLAB = X, READ
By accessing this register, the host CPU can
determine the highest priority interrupt and its
source. Four levels of priority interrupt exist. They
are in descending order of priority:
1.
2.
3.
4.
Information indicating that a prioritized interrupt is
pending and the source of that interrupt is stored
in the Interrupt Identification Register (refer to
Interrupt Control Table). When the CPU accesses
the IIR, the Serial Port freezes all interrupts and
indicates the highest priority
Receiver Line Status (highest priority)
Received Data Ready
Transmitter Holding Register Empty
MODEM Status (lowest priority)
This bit is self-
This bit is self-
70
pending interrupt to the CPU. During this CPU
access, even if the Serial Port records new
interrupts, the current indication does not change
until access is completed. The contents of the IIR
are described below.
Bit 0
This bit can be used in either a hardwired
prioritized or polled environment to indicate
whether an interrupt is pending. When bit 0 is a
logic "0", an interrupt is pending and the contents
of the IIR may be used as a pointer to the
appropriate internal service routine. When bit 0 is
a logic "1", no interrupt is pending.
Bits 1 and 2
These two bits of the IIR are used to identify the
highest priority interrupt pending as indicated by
the Interrupt Control Table.
Bit 3
In non-FIFO mode, this bit is a logic "0". In FIFO
mode this bit is set along with bit 2 when a timeout
interrupt is pending.
Bits 4 and 5
These bits of the IIR are always logic "0".
Bits 6 and 7
These two bits are set when the FIFO CONTROL
Register bit 0 equals 1.
Bit 7
0
0
1
1
Bit 6
0
1
0
1
Trigger Level (BYTES)
RCVR FIFO
14
1
4
8