SC2200UFH-300 AMD (ADVANCED MICRO DEVICES), SC2200UFH-300 Datasheet - Page 324

• Manufacturer Part Number: SC2200UFH-300
• Manufacturer: AMD (ADVANCED MICRO DEVICES)

Specifications of SC2200UFH-300

• Operating Temperature (min): 0C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Not Compliant

7.2.6
The TFT interface can be programmed to one of two sets of
balls: IDE balls or Parallel Port balls. PMR[23] of the Gen-
eral Configuration registers program where the TFT inter-
face exists (see Table 4-2 on page 76).
Note: If the TFT interface is on the IDE balls, the maxi-
Support for a TFT panel requires power sequencing and an
18-bit (6-bit RGB), digital output. The relevant digital output
signals are available from the SC2200.
TFT output signals are:
• TFTD[5:0] for blue signals
• TFTD[11:6] for green signals
• TFTD[17:12] for red signals
• HSYNC and VSYNC - sync signals
336
FP_PWR_EN
FP_VDD_ON
HSYNC, VSYNC,
TFTDE, TFTDCK
mum FPCLK supported is 40 MHz. If the TFT inter-
face is on the Parallel Port balls the maximum
FPCLK supported is 80 MHz.
TFTD[17:0],
TFT Interface
bit
32580B
T
0
T
1
Figure 7-14. TFT Power Sequence
• TFTDCK - data clock signal
• TFTDE - data enable signal
• FP_VDD_ON - power control signal
Power Sequence
Power sequence is used to control assertion of
FP_VDD_ON and TFTD signals.
All bits related to power sequence configuration are located
in the Display Configuration register (F4BAR0+Memory
Offset 04h).
After enabling CRT_EN (bit 0), and FP_PWR_EN (bit 6),
the state machine waits until the next VSYNC to switch on
the FP_VDD_ON signal. The state machine then asserts
the TFTD[17:0] signals after the delay programmed via
PWR_SEQ_DLY (bits [19:17]) When FP_PWR_EN (bit 6)
is set to 0, the reverse sequence happens for powering
down the TFT.
T
T
0
1
is time to next VSYNC
is a programmable multiple of frame time
T
0
AMD Geode™ SC2200 Processor Data Book
+T
1
T
1
Video Processor Module