PCI-BOARD/S25 Altera, PCI-BOARD/S25 Datasheet - Page 11

• Manufacturer Part Number: PCI-BOARD/S25
• Manufacturer: Altera

Specifications of PCI-BOARD/S25

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Altera Corporation
0x000000 - 0x1FFFFF User program area
0x200000 - 0x2FFFFF Stratix factory default configuration image Stratix factory default configuration image
0x300000 - 0x3FFFFF Stratix user configuration image 1
0x400000 - 0x4FFFFF Stratix user configuration image 2
0x500000 - 0x5FFFFF Stratix user configuration image 3
0x600000 - 0x6FFFFF User program area
0x700000 - 0x7FFFFF User program area
Table 7. Flash Memory Device Partitions
Address Range
MAX Configuration Controller
The MAX configuration controller (U1) is an Altera EPM3256ATC144
device. This device is factory-programmed to control Stratix device
configuration, enable read/write access to the flash memory, and select
the image used to configure the Stratix device. The MAX configuration
controller also partitions the flash memory device into functional areas, as
shown in
EP1S60F1020 device, the number of user configuration images available
for the Professional Board is less than the number available for the Starter
Board.
You can select which configuration image the MAX cofiguration
controller device uses to configure the Stratix device at power up by
setting positions 9 and 10 of the board settings dip switch bank (S1). See
Table 8 on page 12
The MAX configuration controller configures the Stratix device when it is
triggered by one of the following events:
If the load is successful, the configuration done LED (D4) illuminates.
The board powers up
The system reset pushbutton (PB3) is pressed
The Stratix device pulses the CPLD_USER0 signal low
Starter Board
Table
7. Due to the larger size of the configuration data for the
for details on the selection.
Stratix PCI Development Board Data Sheet
User program area
Stratix user configuration image 1
Professional Board
11