ATxmega64A1 Atmel Corporation, ATxmega64A1 Datasheet - Page 6

• Manufacturer Part Number: ATxmega64A1
• Manufacturer: Atmel Corporation

Specifications of ATxmega64A1

• Flash (kbytes): 64 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 78
• Ext Interrupts: 78
• Usb Speed: No
• Usb Interface: No
• Spi: 12
• Twi (i2c): 4
• Uart: 8
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 4
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 4
• Eeprom (bytes): 2048
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 8
• Output Compare Channels: 24
• Input Capture Channels: 24
• Pwm Channels: 24
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

8077H–AVR–12/09
Figure 3-1.
The Arithmetic Logic Unit (ALU) supports arithmetic and logic operations between registers or
between a constant and a register. Single register operations can also be executed in the ALU.
After an arithmetic operation, the Status Register is updated to reflect information about the
result of the operation.
The ALU is directly connected to the fast-access Register File. The 32 x 8-bit general purpose
working registers all have single clock cycle access time allowing single-cycle Arithmetic Logic
Unit (ALU) operation between registers or between a register and an immediate. Six of the 32
registers can be used as three 16-bit address pointers for program and data space addressing -
enabling efficient address calculations.
The memory spaces are all linear and regular memory maps. The Data Memory space and the
Program Memory space are two different memory spaces.
The Data Memory space is divided into I/O registers and SRAM. In addition the EEPROM can
be memory mapped in the Data Memory.
All I/O status and control registers reside in the lowest 4K bytes addresses of the Data Memory.
This is referred to as the I/O Memory space. The lowest 64 addresses can be accessed directly,
or as the data space locations from 0x00 - 0x3F. The rest is the Extended I/O Memory space,
ranging from 0x40 to 0x1FFF. I/O registers here must be access as data space locations using
load (LD/LDS/LDD) and store (ST/STS/STD) instructions.
Peripheral
Module 1
Block Diagram of the AVR Architecture
CONTROL
STATUS/
Program
Counter
OCD
Peripheral
Module n
Instruction
Instruction
Program
Register
Memory
Decode
Flash
DATA BUS
SRAM
DATA BUS
ALU
EEPROM
32 x 8 General
Registers
Multiplier/
Purpose
DES
PMIC
XMEGA A
6