TMP86xy12MG Toshiba, TMP86xy12MG Datasheet - Page 102

• Manufacturer Part Number: TMP86xy12MG
• Manufacturer: Toshiba

Specifications of TMP86xy12MG

• Package: SSOP30
• Rom Types (m=mask,p=otp,f=flash): M/F
• Rom Size: 16
• Ram Size: 512
• Driver Led: 8
• Driver Lcd: -
• Spi/sio Channels: 1
• Uart/sio Channels: 1
• I2c/sio Channels: -
• High-speed Serial Output: -
• Adc 8-bit Channels: -
• Adc 10-bit Channels: 8
• Da Converter Channels: -
• Timer Counter 18-bit Channel: IGBT
• Timer Counter 16-bit Channel: 1
• Timer Counter 8-bit Channel: 2
• Motor Channels: -
• Watchdog Timer: Y
• Dual Clock: Y
• Clock Gear: -
• Number Of I/o Ports: 24
• Power Supply (v): 4.5 to 5.5

INTTC7T
INTTC7P
PPG output
Counter
9.4.7 Interrupts
INTTC7T
INTTC7P
PPG output
TC7
Counter
9.4.7.1
9.4.7.2
trigger
CSIDIS specifies
whether the first
INTTC7P occurs.
Note 1: If the pin input level changes while the specified noise elimination threshold is being modified, the noise
Note 2: If noise occurs in synchronization with the internal sampling timing consecutively, it may be assumed as a
Note 3: The signal supplied on the TC7 pin requires 1/fc [s] or less to pass through the F/F.
The TC7 supports three interrupt sources.
Command start
ified with TC7CR1<TRGST>. This interrupt does not occur with a trigger edge for clearing the count. A
trigger edge detected in trigger capture mode does not cause an interrupt. A start trigger causes an inter-
rupt even when the counter is stopped in emergency.
cleared with the specified counter period (TC7DRC) reached, that is, at the end of a period. A match with
the set period causes an interrupt even when the counter is stopped in emergency.
INTTC7T (Trigger start interrupt)
INTTC7P (Period interrupt)
A trigger interrupt (INTTC7T) occurs when the counter starts upon the detection of a trigger edge spec-
A period interrupt (INTTC7P) occurs when the counter starts with a command and when the counter is
canceller may assume noise as a pulse or cancel a pulse as noise.
signal.
x
x
Cleared
1
0
Figure 9-20 Trigger Start Interrupt
2
Figure 9-21 Period Interrupt
1 period
Count started
1
M-2
Clear upon match
2
M-1
TC7DRC
Page 91
1 period
M, 0
M-2
Cleared upon match
M-1
1
TC7DRC
Command stop
Stop at the end of period
2
0
1 period
1
M-2
2
M-1
Cleared
M, 0
0
TMP86CH12MG
Timer stopped
1
2