TMP86xy12MG Toshiba, TMP86xy12MG Datasheet - Page 34

• Manufacturer Part Number: TMP86xy12MG
• Manufacturer: Toshiba

Specifications of TMP86xy12MG

• Package: SSOP30
• Rom Types (m=mask,p=otp,f=flash): M/F
• Rom Size: 16
• Ram Size: 512
• Driver Led: 8
• Driver Lcd: -
• Spi/sio Channels: 1
• Uart/sio Channels: 1
• I2c/sio Channels: -
• High-speed Serial Output: -
• Adc 8-bit Channels: -
• Adc 10-bit Channels: 8
• Da Converter Channels: -
• Timer Counter 18-bit Channel: IGBT
• Timer Counter 16-bit Channel: 1
• Timer Counter 8-bit Channel: 2
• Motor Channels: -
• Watchdog Timer: Y
• Dual Clock: Y
• Clock Gear: -
• Number Of I/o Ports: 24
• Power Supply (v): 4.5 to 5.5

2.2.4.3
timer control register (TBTCR). The following status is maintained during IDLE0 and SLEEP0 modes.
IDLE0 and SLEEP0 modes (IDLE0, SLEEP0)
IDLE0 and SLEEP0 modes are controlled by the system control register 2 (SYSCR2) and the time base
Note: Before starting IDLE0 or SLEEP0 mode, be sure to stop (Disable) peripherals.
1. Timing generator stops feeding clock to peripherals except TBT.
2. The data memory, CPU registers, program status word and port output latches are all held in the
3. The program counter holds the address 2 ahead of the instruction which starts IDLE0 and
status in effect before IDLE0 and SLEEP0 modes were entered.
SLEEP0 modes.
(Normal release mode)
Figure 2-12 IDLE0 and SLEEP0 Modes
No
No
No
No
CPU and WDT are halted
Execution of the instruction
which follows the IDLE0,
Page 23
Starting IDLE0, SLEEP0
Stopping peripherals
Interrupt processing
SLEEP0 modes start
modes by instruction
TBTCR<TBTEN>
by instruction
TBT interrupt
source clock
Reset input
IMF = "1"
instruction
enable
falling
= "1"
edge
TBT
Yes
Yes
No
Yes
Yes (Interrupt release mode)
Yes
Reset
TMP86CH12MG