upd78f0103hmca1-5a4-a Renesas Electronics Corporation., upd78f0103hmca1-5a4-a Datasheet - Page 275

• Manufacturer Part Number: upd78f0103hmca1-5a4-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

14.1 Interrupt Function Types
(1) Maskable interrupts
(2) Software interrupt
14.2 Interrupt Sources and Configuration
sources are also provided (see Table 14-1).
The following two types of interrupt functions are used.
A total of 19 interrupt sources exist for maskable and software interrupts. In addition, maximum total of 5 reset
These interrupts undergo mask control. Maskable interrupts can be divided into a high interrupt priority group
and a low interrupt priority group by setting the priority specification flag registers (PR0L, PR0H, PR1L).
Multiple interrupt servicing of high-priority interrupts can be applied to low priority interrupts. If two or more
interrupts with the same priority are simultaneously generated, each interrupt is serviced according to its
predetermined priority (see Table 14-1).
A standby release signal is generated and the STOP mode and HALT mode are released by maskable interrupts.
Six external interrupt requests and 12 internal interrupt requests are provided as maskable interrupts.
This is a vectored interrupt generated by executing the BRK instruction. It is acknowledged even when interrupts
are disabled. The software interrupt does not undergo interrupt priority control.
CHAPTER 14 INTERRUPT FUNCTIONS
User’s Manual U16846EJ3V0UD
275