pcf8833 NXP Semiconductors, pcf8833 Datasheet - Page 66

• Manufacturer Part Number: pcf8833
• Description: Stn Rgb - 132 X 132 X 3 Driver
• Manufacturer: NXP Semiconductors

Philips Semiconductors
7.3
The command decoder identifies command words arriving
at the interface and routes the following data bytes to their
destination. The command set is given in Chapter 6.
7.4
For a grey scale driving scheme, Frame Rate Control
(FRC) with carefully controlled mixing of the FRC pattern
on each pixel is used. The special mixing ensures that the
pattern placed on each pixel is different from each of its
neighbours. In frame rate control 16 frames form together
to produce a super-frame. All 16 frames have the same
duration.
7.5
The timing generator produces the various signals
required to drive the internal circuitry. Internal chip
operation is not affected by operations on the data bus.
7.6
The on-chip oscillator provides the clock signal for the
display system. No external components are required and
the OSC input must be connected to V
clock signal, if used, is connected to the OSC input. In this
case the internal oscillator must be switched off by a
software command; see Section 6.2.38.
7.7
The chip has a hardware and a software reset. After
power-up a hardware reset (pin RES) must be applied.
The hardware and software reset give the same results.
After a reset, the chip has the following state; see
Section 6.2.2:
Table 85 External components
2003 Feb 14
STN RGB - 132
Command decoder
Grey scale controller
Timing generator
Oscillator
Reset
C1 to C4; C
C5; C
C
C
ITEM
VDD2
VDD1
VLCD2
VLCD1
132
DD1
3 driver
. An external
CAPACITOR VALUE
1 to 4.7 F
1 to 4.7 F
1 to 4.7 F
1 F
66
7.8
The LCD voltage generator and the bias level generator is
illustrated in Fig.37. The V
two voltage multipliers, with voltage multiplier 1 being
programmable; see Section 6.2.39.
Behaviour of voltage multiplier 2 depends on the mode.
In the full Display mode, voltage multiplier 2 behaves as a
doubler. In the partial Display mode voltage multiplier 2
feeds the voltage of V
The LCD voltage generator requires in total 9 external
components (capacitors). The recommended values and
voltage ranges for the external components are specified
in Table 85. The given values should be referred to as
information only. It is recommended to check how patterns
with high load are displayed before finalizing the values.
The bias level generator generates the required bias levels
according to the programmed bias systems; see
Section 6.2.43.
To save power it is recommended to apply capacitors to
bias level pads (V2H, V1H, VC, V1L and V2L) of
approximately 1 F. A capacitor at VC pad is expected to
be the most effective. Depending on the application of the
VC capacitor it might be advantageous or even necessary
to set the OPT bit VCBW = 1; see Table 97 and
Section 15.8.
All column and row outputs are set to V
RAM data undefined
Power-down mode
Command register set to default states; see Table 4.
LCD voltage generator and bias level generator
LCDIN1
LCD
VOLTAGE RANGE
directly to V
is generated by means of
Objective specification
4.5 V
3.3 V
16 V
25 V
LCDOUT2
PCF8833
SS1
(display off)
.