tmp89fm82t TOSHIBA Semiconductor CORPORATION, tmp89fm82t Datasheet - Page 54

• Manufacturer Part Number: tmp89fm82t
• Description: 8 Bit Microcontroller
• Manufacturer: TOSHIBA Semiconductor CORPORATION

2.3
System clock controller
RA000
・ Start the IDLE0 and SLEEP0 modes
・ Release the IDLE0 and SLEEP0 modes
These modes are selected at the interrupt master enable flag (IMF), the individual interrupt enable
flag (EF5) for the time base timer and TBTCR<TBTEN>. After releasing the IDLE0 or SLEEP0
mode, SYSCR2<TGHALT> is automatically cleared to "0" and the operation mode is returned to
the mode preceding the IDLE0 or SLEEP0 mode. If TBTCR<TBTEN> has been set at "1", the
INTTBT interrupt latch is set.
and a reset by the voltage detection circuits. When a reset is released, the warm-up starts. After
the warm-up is completed, the NORMAL1 mode becomes active.
Stop (disable) the peripherals such as a timer counter.
To start the IDLE0 or SLEEP0 mode, set SYSCR2<TGHALT> to "1".
The IDLE0 and SLEEP0 modes include a normal release mode and an interrupt release mode.
The IDLE0 and SLEEP0 modes are also released by a reset by the RESET pin, a power-on reset
(Normal release mode)
Figure 2-13 IDLE0 and SLEEP0 Modes
No
"0"
No
No
Execution of the instruction
which follows the IDLE0 or
Starting IDLE0 or SLEEP0
Stopping peripherals by
mode by an instruction
Page 38
SLEEP0 mode start
Interrupt processing
CPU and WDT stop
TBTCR<TBTEN>
TBT source clock
TBT interrupt
instructions
Reset input
instruction
falling edge
IMF = "1"
enabled
No
Yes
Yes
"1"
Yes
(Interrupt release mode)
Yes
Reset
TMP89FM82T