ST10F272M-4Q3 STMICROELECTRONICS [STMicroelectronics], ST10F272M-4Q3 Datasheet - Page 58

• Manufacturer Part Number: ST10F272M-4Q3
• Description: 16-bit MCU with 256 Kbyte Flash memory and 20 Kbyte RAM
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

General purpose timer unit
11
11.1
Table 34.
58/176
Prescaler factor
Input frequency
Resolution
Period maximum
f
CPU
= 40 MHz
General purpose timer unit
The GPT unit is a flexible multifunctional timer/counter structure which is used for time
related tasks such as event timing and counting, pulse width and duty cycle measurements,
pulse generation, or pulse multiplication. The GPT unit contains five 16-bit timers organized
into two separate modules GPT1 and GPT2. Each timer in each module may operate
independently in several different modes, or may be concatenated with another timer of the
same module.
GPT1
Each of the three timers T2, T3, T4 of the GPT1 module can be configured individually for
one of four basic modes of operation: timer, gated timer, counter mode and incremental
interface mode.
In timer mode, the input clock for a timer is derived from the CPU clock, divided by a
programmable prescaler.
In counter mode, the timer is clocked in reference to external events.
Pulse width or duty cycle measurement is supported in gated timer mode where the
operation of a timer is controlled by the ‘gate’ level on an external input pin. For these
purposes, each timer has one associated port pin (TxIN) which serves as gate or clock
input.
Table 34
40 MHz CPU clock.
In Incremental Interface mode, the GPT1 timers (T2, T3, T4) can be directly connected to
the incremental position sensor signals A and B by their respective inputs TxIN and TxEUD.
Direction and count signals are internally derived from these two input signals so that the
contents of the respective timer Tx corresponds to the sensor position. The third position
sensor signal TOP0 can be connected to an interrupt input.
Timer T3 has output toggle latches (TxOTL) which changes state on each timer over flow /
underflow. The state of this latch may be output on port pins (TxOUT) for time out monitoring
of external hardware components, or may be used internally to clock timers T2 and T4 for
high resolution of long duration measurements.
In addition to their basic operating modes, timers T2 and T4 may be configured as reload or
capture registers for timer T3.
GPT1 timer input frequencies, resolutions and periods at 40 MHz
13.1ms
5 MHz
200ns
000b
lists the timer input frequencies, resolution and periods for each prescaler option at
8
2.5 MHz
26.2ms
400ns
001b
16
1.25 MHz
52.4ms
0.8µs
010b
32
Timer input selection T2I / T3I / T4I
104.8 ms
625 kHz
1.6µs
011b
64
312.5 kHz 156.25 kHz 78.125 kHz 39.1 kHz
209.7ms
3.2µs
100b
128
419.4ms
6.4µs
101b
256
838.9ms
12.8µs
110b
512
ST10F272M
25.6µs
1.678s
111b
1024