CN8380EPF CONEXANT [Conexant Systems, Inc], CN8380EPF Datasheet - Page 23

• Manufacturer Part Number: CN8380EPF
• Description: integrated quad line interface unit unit for both 1.544 Mbps (T1) and 2.048 Mbps (E1) applications
• Manufacturer: CONEXANT [Conexant Systems, Inc]

N8380DSA
2.0 Circuit Description
2.1 Overview
The CN8380 includes four identical T1/E1 transceiver channels and a common
CLAD packaged in a 128-pin MQFP carrier. It is designed to interface T1/E1
framers, or to operate as a stand-alone line interface for synchronous or
plesiochronous mappers and multiplexers. The CN8380 is ideal for high line
density, short-haul applications that require low power (3.3 V supply) operation.
The configurable T1/E1 operation and common line interface design allows
support for single-board T1 and E1 designs.
conforms to AT&T PUB 62411 and a selectable transmit pulse shape which
conforms to FCC Part 68, Pulse Option A. Selectable unipolar or bipolar interface
options and internal ZCS encoding and decoding are useful in many multiplexer
and mapper applications.
using dedicated hardware control pins. In this mode, the four channels are
configured globally to identical operating modes (T1, E1, transmit termination,
jitter attenuators, and so on). Each channel has device pins dedicated for channel
control and status, such as loopback controls, bipolar/unipolar interface modes,
and loss of signal indicators. Hardware Mode is selected by pulling the HM pin
high.
mode, all control and status functions can be accessed using internal registers.
Several additional features are also available in Host Mode, such as individual
channel operating mode configuration (T1/E1, transmit termination, jitter
attenuators, etc.) and programmable CLAD output frequencies. Host Mode is
selected by grounding the HM pin.
compliance with IEEE Std P1149.1a–1993, IEEE Standard Test Access Port and
Boundary–Scan Architecture, commonly known as JTAG (Joint Test Action
Group). A detailed block diagram is displayed in
Customer premise applications are supported by an on-chip JAT which
In the most simple configuration, Hardware Mode, the device is controlled
Host Mode allows control of the device through a 4-line serial port. In this
The CN8380 incorporates printed circuit board testability circuits in
Advance Information
Conexant
2
Figure
2-1.
2-1