MT47H32M16HR-25E AIT:G Micron, MT47H32M16HR-25E AIT:G Datasheet - Page 115

• Manufacturer Part Number: MT47H32M16HR-25E AIT:G
• Description: DRAM Chip DDR2 SDRAM 512M-Bit 32Mx16 1.8V 84-Pin FBGA
• Manufacturer: Micron

Table 43: Truth Table – CKE
Notes 1–4 apply to the entire table
PDF: 09005aef8440dbbc
512mbddr2_ait_aat.pdf – Rev. C 7/11 EN
Current State
Bank(s) active
All banks idle
Power-down
Self refresh
Previous Cycle
Notes:
(n - 1)
H
H
H
H
L
L
L
L
10. Valid commands for self refresh exit are NOP and DESELECT only.
11. Power-down and self refresh can not be entered while READ or WRITE operations,
12. Minimum CKE high time is
13. Self refresh mode can only be entered from the all banks idle state.
14. Must be a legal command, as defined in Table 36 (page 66).
1. CKE (n) is the logic state of CKE at clock edge n; CKE (n - 1) was the state of CKE at the
2. Current state is the state of the DDR2 SDRAM immediately prior to clock edge n.
3. Command (n) is the command registered at clock edge n, and action (n) is a result of
4. The state of ODT does not affect the states described in this table. The ODT function is
5. Power-down modes do not perform any REFRESH operations. The duration of power-
6. “X” means “Don’t Care” (including floating around V
7. All states and sequences not shown are illegal or reserved unless explicitly described
8. Valid commands for power-down entry and exit are NOP and DESELECT only.
9. On self refresh exit, DESELECT or NOP commands must be issued on every clock edge oc-
previous clock edge.
command (n).
not available during self refresh (see ODT Timing (page 123) for more details and spe-
cific restrictions).
down mode is therefore limited by the refresh requirements.
down. However, ODT must be driven high or low in power-down if the ODT function is
enabled via EMR.
elsewhere in this document.
curring during the
clocks) is satisfied.
LOAD MODE operations, or PRECHARGE operations are in progress. See SELF REFRESH
(page 111) and SELF REFRESH (page 72) for a list of detailed restrictions.
This requires a minimum of 3 clock cycles of registration.
CKE
Micron Confidential and Proprietary
Cycle (n)
Current
H
H
H
L
L
L
L
L
t
XSNR period. READ commands may be issued only after
CS#, RAS#, CAS#,
115
DESELECT or NOP
DESELECT or NOP
DESELECT or NOP
DESELECT or NOP
Command (n)
512Mb: x8, x16 Automotive DDR2 SDRAM
t
CKE = 3 ×
Refresh
WE#
Shown in Table 36 (page 66)
X
X
Micron Technology, Inc. reserves the right to change products or specifications without notice.
t
CK. Minimum CKE LOW time is
Active power-down en-
Precharge power-down
Maintain power-down
Maintain self refresh
Power-down exit
Self refresh entry
Self refresh exit
Action (n)
REF
entry
) in self refresh and power-
try
Power-Down Mode
‹ 2010 Micron Technology, Inc. All rights reserved.
t
CKE = 3 ×
7, 8, 11, 12
10, 12, 13
t
7, 9, 10
7, 8, 11
XSRD (200
Notes
5, 6
7, 8
14
6
t
CK.