C8051F350DK Silicon Laboratories Inc, C8051F350DK Datasheet - Page 88

• Manufacturer Part Number: C8051F350DK
• Description: DEV KIT FOR F350/351/352/353
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F350DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F35x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F350
• Silicon Family Name: C8051F35x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F350, 351, 352, 353
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1083

C8051F350/1/2/3
Performance
The CIP-51 employs a pipelined architecture that greatly increases its instruction throughput over the stan-
dard 8051 architecture. In a standard 8051, all instructions except for MUL and DIV take 12 or 24 system
clock cycles to execute, and usually have a maximum system clock of 12 MHz. By contrast, the CIP-51
core executes 70% of its instructions in one or two system clock cycles, with no instructions taking more
than eight system clock cycles.
With the CIP-51's system clock running at 50 MHz, it has a peak throughput of 50 MIPS. The CIP-51 has a
total of 109 instructions. The table below shows the total number of instructions that require each execution
time.
Programming and Debugging Support
In-system programming of the Flash program memory and communication with on-chip debug support
logic is accomplished via the Cygnal 2-Wire (C2) interface. Note that the re-programmable Flash can also
be read and changed a single byte at a time by the application software using the MOVC and MOVX
instructions. This feature allows program memory to be used for non-volatile data storage as well as updat-
ing program code under software control.
The on-chip debug support logic facilitates full speed in-circuit debugging, allowing the setting of hardware
breakpoints, starting, stopping and single stepping through program execution (including interrupt service
routines), examination of the program's call stack, and reading/writing the contents of registers and mem-
ory. This method of on-chip debugging is completely non-intrusive, requiring no RAM, Stack, timers, or
other on-chip resources.
The CIP-51 is supported by development tools from Silicon Labs and third party vendors. Silicon Labs pro-
vides an integrated development environment (IDE) including editor, macro assembler, debugger and pro-
grammer. The IDE's debugger and programmer interface to the CIP-51 via the on-chip debug logic to
provide fast and efficient in-system device programming and debugging. Third party macro assemblers
and C compilers are also available.
88
Number of Instructions
Clocks to Execute
26
1
50
2
2/3
Rev. 1.1
5
14
3
3/4
7
4
3
4/5
1
5
2
8
1