AT32UC3C2512C Atmel Corporation, AT32UC3C2512C Datasheet - Page 459

• Manufacturer Part Number: AT32UC3C2512C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C2512C

• Flash (kbytes): 512 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 68
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

23.6.2.8
32117C–AVR-08/11
CPU Local Bus
Figure 23-4. Interrupt Timing with Glitch Filter Disabled
Figure 23-5
enabled. For the pulse to be registered, it must be sampled on two subsequent rising edges. In
the example, the first pulse is rejected while the second pulse is accepted and causes an inter-
rupt request.
Figure 23-5. Interrupt Timing with Glitch Filter Enabled
The CPU Local Bus can be used for application where low latency read and write access to the
Output Value Register (OVR) and Output Drive Enable Register (ODER) is required. The CPU
Local Bus allows the CPU to configure the mentioned GPIO registers directly, bypassing the
shared Peripheral Bus (PB).
To avoid data loss when using the CPU Local Bus, the CLK_GPIO must run at the same fre-
quency as the CLK_CPU. See
The CPU Local Bus is mapped to a different base address than the GPIO but the OVER and
ODER offsets are the same. See the CPU Local Bus Mapping section in the Memories chapter
for details.
CLK_GPIO
CLK_GPIO
Pin Level
Pin Level
IFR
IFR
shows the timing for rising edge (or pin-change) interrupts when the glitch filter is
Section 23.5.2
for details.
AT32UC3C
459