AT32UC3C2512C Atmel Corporation, AT32UC3C2512C Datasheet - Page 619

• Manufacturer Part Number: AT32UC3C2512C
• Manufacturer: Atmel Corporation

Specifications of AT32UC3C2512C

• Flash (kbytes): 512 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 45
• Ext Interrupts: 64
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 2
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 68
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6 or 4.5 to 5.5
• Operating Voltage (vcc): 3.0 to 3.6 or 4.5 to 5.5
• Fpu: Yes
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 13
• Input Capture Channels: 6
• Pwm Channels: 14
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

25.6.13
32117C–AVR-08/11
Wake-up Request
Any node in a sleeping LIN cluster may request a wake-up.
In the LIN 2.0 specification, the wakeup request is issued by forcing the bus to the dominant
state from 250 µs to 5 ms. For this, it is necessary to send the character 0xF0 in order to impose
5 successive dominant bits. Whatever the baud rate is, this character respects the specified
timings.
In the LIN 1.3 specification, the wakeup request should be generated with the character 0x80 in
order to impose 8 successive dominant bits.
The user can choose by the WKUPTYP bit in the LIN Mode register (LINMR) either to send a
LIN 2.0 wakeup request (WKUPTYP=0) or to send a LIN 1.3 wakeup request (WKUPTYP=1).
A wake-up request is transmitted by writing the Control Register (CR) with the LINWKUP bit at 1.
Once the transfer is completed, the LINTC flag is asserted in the Status Register (SR). It is
cleared by writing the Control Register (CR) with the RSTSTA bit at 1.
• Baud rate min = 1 kbit/s -> Tbit = 1ms -> 5 Tbits = 5 ms
• Baud rate max = 20 kbit/s -> Tbi t= 50 µs -> 5 Tbits = 250 µs
AT32UC3C
619