HD6473834HV Renesas Electronics America, HD6473834HV Datasheet - Page 308

• Manufacturer Part Number: HD6473834HV
• Description: MCU 5V 32K PB-FREE 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Lr

Specifications of HD6473834HV

• Core Processor: H8/300L
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: SCI
• Peripherals: LCD, PWM
• Number Of I /o: 71
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: OTP
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 12x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

10.4.7
SCI3 has six interrupt sources: transmit end, transmit data empty, receive data full, and the three
receive error interrupts (overrun error, framing error, and parity error). All share a common
interrupt vector. Table 10.18 describes each interrupt.
Table 10.18 SCI3 Interrupts
Interrupt
RXI
TXI
TEI
ERI
The interrupt requests are enabled and disabled by bits TIE and RIE of SCR3.
When bit TDRE in SSR is set to 1, TXI is requested. When bit TEND in SSR is set to 1, TEI is
requested. These two interrupt requests occur during data transmission.
The initial value of bit TDRE is 1. Accordingly, if the transmit data empty interrupt request (TXI)
is enabled by setting bit TIE to 1 in SCR3 before placing transmit data in TDR, TXI will be
requested even though no transmit data has been readied.
Likewise, the initial value of bit TEND is 1. Accordingly, if the transmit end interrupt request
(TEI) is enabled by setting bit TEIE to 1 in SCR3 before placing transmit data in TDR, TEI will be
requested even though no data has been transmitted.
These interrupt features can be used to advantage by programming the interrupt handler to move
the transmit data into TDR. When this technique is not used, the interrupt enable bits (TIE and
TEIE) should not be set to 1 until after TDR has been loaded with transmit data, to avoid
unwanted TXI and TEI interrupts.
When bit RDRF in SSR is set to 1, RXI is requested. When any of SSR bits OER, FER, or PER is
set to 1, ERI is requested. These two interrupt requests occur during the receiving of data.
Details on interrupts are given in 3.3, Interrupts.
Interrupts
Description
Interrupt request due to receive data register full (RDRF)
Interrupt request due to transmit data register empty (TDRE)
Interrupt request due to transmit end (TEND)
Interrupt request due to receive error (OER, FER, or PER)
Vector Address
H'0024
291