Chameleon-AVR Nurve Networks, Chameleon-AVR Datasheet - Page 117

• Manufacturer Part Number: Chameleon-AVR
• Description: MCU, MPU & DSP Development Tools AVR8 & PROPELLER DEV SYSTEM (SBC)
• Manufacturer: Nurve Networks

Specifications of Chameleon-AVR

• Processor To Be Evaluated: AVR 328P
• Data Bus Width: 8 bit
• Interface Type: USB, VGA, PS/2, I2C, ISP, SPI
• Operating Supply Voltage: 3.3 V, 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

© 2009 NURVE NETWORKS LLC “Exploring the Chameleon AVR 8-Bit”
Figure 15.55 – Selecting the proper AT328P target for the Arduino tool.
Next, we need to make sure that the Arduino tool is using the proper serial port. You should have noted this earlier when
you plugged the USB cable into the Chameleon and the PC recognized the FTDI USB to serial chip. If you haven’t done
then, plug the USB cable in, and go thru the installation of the FTDI drivers. Then take not in the Control Panel where the
new USB serial port was installed, you need that information for this step.
Setting the COM Port
To set the Arduino tool’s COM port, simply select from the main menu <Tools → Serial Port> as shown in Figure 15.56
and select the proper serial port.
117