CYIL2SM1300AA-GZDC Cypress Semiconductor Corp, CYIL2SM1300AA-GZDC Datasheet - Page 6

• Manufacturer Part Number: CYIL2SM1300AA-GZDC
• Description: IMAGE SENSOR CMOS LUPA-1300-3
• Manufacturer: Cypress Semiconductor Corp
• Type: CMOS Imagingr

Specifications of CYIL2SM1300AA-GZDC

• Package / Case: 168-PGA
• Pixel Size: 14µm x 14µm
• Active Pixel Array: 1280H x 1024V
• Frames Per Second: 500
• Voltage - Supply: 2.5V, 3.3V
• Operating Supply Voltage: 2.5 V
• Maximum Power Dissipation: 1350 mW
• Maximum Operating Temperature: + 70 C
• Supply Current: 80 mA
• Minimum Operating Temperature: 0 C
• Package: 168CuPGA
• Image Size: 1280x1024 Pixels
• Color Sensing: Monochrome
• Operating Temperature: 0 to 70 °C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Overview
This data sheet describes the interface of the LUPA1300-2
image sensor. The SXGA resolution CMOS active pixel sensor
features synchronous shutter and a maximal frame rate of
500 fps in full resolution. The readout speed is boosted by sub
sampling and the windowed region of interest (ROI) readout.
FPN correction cannot be used in conjunction with sub-sampling
and windowed region of interest readout for windows starting
with non zero kernel address. High dynamic range scenes can
be captured using the double and multiple slope functionality.
User programmable row and column start and stop positions
enables windowing. Sub sampling reduces resolution while
maintaining the constant field of view and an increased frame
rate.
The LUPA1300-2 sensor has 12 LVDS high speed outputs that
transfer image data over longer distances. This simplifies the
surrounding system. The LVDS interface can receive high speed
Photovoltaic Response Curve
Document Number: 001-24599 Rev. *F
Figure 2. Photovoltaic Response of LUPA 1300-2
and wide bandwidth data signals and maintain low noise and
distortion. A special training mode enables the receiving system
to synchronize the incoming data stream when switching to
master, slave, or triggered mode. The image sensor also
integrates a programmable offset and gain amplifier for each
channel.
A 10-bit ADC converts the analog signal to a 10-bit digital word
stream. The sensor uses a 3-wire Serial Peripheral Interface
(SPI). It requires only one master clock for operation up to 500
fps.
The sensor is available in a monochrome version or Bayer (RGB)
patterned color filter array. It is placed in a 168-pin ceramic µPGA
package.
Figure 2
Figure 3
versions of LUPA 1300-2.
depicts the photovoltaic response of the LUPA 1300-2.
shows the spectral response for the mono and color
CYIL2SM1300AA
Page 6 of 43
[+] Feedback