DS26518GN+ Maxim Integrated Products, DS26518GN+ Datasheet - Page 93

• Manufacturer Part Number: DS26518GN+
• Description: IC TXRX T1/E1/J1 8PORT 256-CSBGA
• Manufacturer: Maxim Integrated Products
• Type: Transceiverr

Specifications of DS26518GN+

• Number Of Drivers/receivers: 8/8
• Protocol: T1/E1/J1
• Voltage - Supply: 3.135 V ~ 3.465 V
• Mounting Type: Surface Mount
• Package / Case: 256-CSBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.12.3.4
The receive equalizer is equipped with a monitor mode function that is used to overcome the signal attenuation
caused by the resistive bridge used in monitoring applications. This function allows for a resistive gain of up to
32dB along with cable attenuation of 12dB to 30dB as shown in the LIU Receive Control Register (LRCR).
Figure 9-25. Typical Monitor Application
9.12.3.5
The DS26518 uses both the digital and analog loss-detection method in compliance with the latest T1.231 for
T1/J1 and ITU-T G.775 or ETS 300 233 for E1 mode of operation.
LOS is detected if the receiver level falls bellow a threshold analog voltage for certain duration. Alternatively, this
can be termed as having received “zeros” for a certain duration. The signal level and timing duration are defined in
accordance with the T1.231 or G.775 or ETS 300 233 specifications.
For short-haul mode, the loss-detection thresholds are based on cable loss of 12dB to 18dB for both T1/J1 and E1
modes. The loss thresholds are selectable based on
is based on cable loss of 30dB to 38dB for T1/J1 and 30dB to 45dB for E1 mode. Note there is no explicit bit called
short-haul mode selection. Loss declaration level is set at 3dB lower than the maximum sensitivity setting
programmed in
The loss state is exited when the receiver detects a certain ones density at the maximum sensitivity level or higher,
which is 3dB higher than the loss-detection level. The loss-detection signal level and loss-reset signal level are
defined with hysteresis to prevent the receiver from bouncing between “LOS” and “no LOS” states.
outlines the specifications governing the loss function.
Table
Receiver Monitor Mode
Loss of Signal
T1/E1 LINE
10-22.
Rm
MONITOR
PORT JACK
Rm
PRIMARY
T1/E1 TERMINATING
DEVICE
Table 10-22.
93 of 312
X
F
M
R
For long-haul mode, the LOS-detection threshold
SECONDARY T1/E1
TERMINATING
DEVICE
Rt
DS2651x
Table 9-43