WM8310GEB/V Wolfson Microelectronics, WM8310GEB/V Datasheet - Page 120

• Manufacturer Part Number: WM8310GEB/V
• Description: POWER MANAGEMENT SUBSYSTEM, 169BGA
• Manufacturer: Wolfson Microelectronics

Specifications of WM8310GEB/V

• Supply Voltage: 7V
• No. Of Step-down Dc - Dc Converters: 4
• No. Of Ldo Regulators: 11
• Digital Ic Case Style: BGA
• No. Of Pins: 169
• No. Of Regulated Outputs: 13
• Operating Temperature Range: -40°C To
• Rohs Compliant: Yes
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

WM8310
18.3 AUXADC READBACK
w
Measured data from the AUXADC is read via the AuxADC Data Register (R16429), which contains
two fields. The AUXADC Data Source is indicated in the AUX_DATA_SRC field; the associated
measurement data is contained in the AUX_DATA field.
Reading from the AuxADC Data Register returns a 12-bit code which represents the most recent
AUXADC measurement on the associated channel. It should be noted that every time an AUXADC
measurement is written to the AuxADC Data Register, the previous data is overwritten - the host
processor should ensure that data is read from this register before it is overwritten. The AUXADC
interrupts can be used to indicate when new data is available - see Section 18.5.
The 12-bit AUX_DATA field can be equated to the actual voltage (or temperature) according to the
following equations, where AUX_DATA is regarded as an unsigned integer:
Battery Temperature measurement varies according to the selected NTC thermistor component.
In a typical application, it is anticipated that the AUXADC Interrupts would be used to control the
AUXADC readback - the host processor should read the AUXADC Data Register in response to the
AUXADC Interrupt event. See Section 18.5 for details of AUXADC Interrupts. In Automatic AUXADC
mode, the processor should complete this action before the next measurement occurs, in order to
avoid losing any AUXADC samples. In Manual conversion mode, the interrupt signal provides
confirmation that the commanded measurement has been completed.
The control fields associated with initiating AUXADC readback are defined in Table 67.
R16429
(402Dh)
AuxADC Data
Table 67 AUXADC Readback
ADDRESS
15:12
11:0
BIT
AUX_DATA_SRC
[3:0]
AUX_DATA [11:0]
LABEL
DEFAULT
000h
000
AUXADC Data Source
0 = Reserved
1 = AUXADCIN1
2 = AUXADCIN2
3 = AUXADCIN3
4 = AUXADCIN4
5 = Chip Temperature
6 = Battery Temperature
7 = SYSVDD voltage
8 = USB voltage
9 = BATT voltage
10 = WALL voltage
11 = Backup Battery voltage
12 = Reserved
13 = Reserved
14 = Reserved
15 = Reserved
AUXADC Measurement Data
Voltage (mV) = AUX_DATA x 1.465
ChipTemp (°C) = (512.18 - AUX_DATA) /
1.0983
BattTemp (°C) = (value is dependent on
NTC thermistor)
PP, December 2009, Rev 3.0
DESCRIPTION
Pre-Production
120