TRK-USB-MPC5643L Freescale Semiconductor, TRK-USB-MPC5643L Datasheet - Page 14

• Manufacturer Part Number: TRK-USB-MPC5643L
• Description: Development Boards & Kits - Other Processors StarTrakMiniUSG MPC5643L
• Manufacturer: Freescale Semiconductor

Specifications of TRK-USB-MPC5643L

• Rohs: yes
• Product: Starter Kits
• Tool Is For Evaluation Of: MPC5643L
• Core: Five Stage Pipeline
• Interface Type: LIN, DSPI
• Operating Supply Voltage: 3 V to 3.6 V
• Data Bus Width: 32 bit, 64 bit
• Description/function: Starter Kit for MPC5643L
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• For Use With: MPC5643L

Introduction
1.5.21
The FCCU module has the following features:
1.5.22
The SIUL controls MCU reset configuration, pad configuration, external interrupt, general purpose I/O (GPIO), internal
peripheral multiplexing, and system reset operation. The reset configuration block contains the external pin boot configuration
logic. The pad configuration block controls the static electrical characteristics of I/O pins. The GPIO block provides uniform
and discrete input/output control of the I/O pins of the MCU.
The SIU provides the following features:
1.5.23
The non-maskable interrupt with de-glitching filter supports high-priority core exceptions.
1.5.24
The BAM is a block of read-only memory with hard-coded content. The BAM program is executed only if serial booting mode
is selected via boot configuration pins.
The BAM provides the following features:
1.5.25
The SSCM on this device features the following:
14
•
•
•
•
•
•
•
•
•
•
•
•
•
Redundant collection of hardware checker results
Redundant collection of error information and latch of faults from critical modules on the device
Collection of self-test results
Configurable and graded fault control
— Internal reactions (no internal reaction, IRQ, Functional Reset, Destructive Reset, or Safe mode entered)
— External reaction (failure is reported to the external/surrounding system via configurable output pins)
Centralized pad control on a per-pin basis
— Pin function selection
— Configurable weak pull-up/down
— Configurable slew rate control (slow/medium/fast)
— Hysteresis on GPIO pins
— Configurable automatic safe mode pad control
Input filtering for external interrupts
Enables booting via serial mode (FlexCAN or LINFlex-UART)
Supports programmable 64-bit password protection for serial boot mode
Supports serial bootloading of either Power Architecture code (default) or Freescale VLE code
Automatic switch to serial boot mode if internal flash memory is blank or invalid
System configuration and status
Debug port status and debug port enable
Multiple boot code starting locations out of reset through implementation of search for valid Reset Configuration Half
Word
Fault Collection and Control Unit (FCCU)
System Integration Unit Lite (SIUL)
Non-Maskable Interrupt (NMI)
Boot Assist Module (BAM)
System Status and Configuration Module (SSCM)
MPC5643L Microcontroller Data Sheet, Rev. 8.1
Freescale Semiconductor