C8051F060-TB Silicon Laboratories Inc, C8051F060-TB Datasheet - Page 33

• Manufacturer Part Number: C8051F060-TB
• Description: BOARD PROTOTYPING W/C8051F060
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F060-TB

• Contents: Board
• Processor To Be Evaluated: C8051F06x
• Interface Type: USB
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F060
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

1.8.
The C8051F060/1/2/3/4/5/6/7 devices have two on-chip 16-bit SAR ADCs (ADC0 and ADC1), which can
be used independently in single-ended mode, or together in differential mode. ADC0 and ADC1 can
directly access on-chip or external RAM, using the DMA interface. With a maximum throughput of 1 Msps,
the ADCs offer 16 bit performance with two available linearity grades. ADC0 and ADC1 each have the
capability to use dedicated, on-chip voltage reference circuitry or an external voltage reference source.
The ADCs are under full control of the CIP-51 microcontroller via the associated Special Function Regis-
ters. The system controller can also put the ADCs into shutdown mode to save power.
Conversions can be started in four ways; a software command, an overflow of Timer 2, an overflow of
Timer 3, or an external signal input. This flexibility allows the start of conversion to be triggered by software
events, external HW signals, or a periodic timer overflow signal. The two ADCs can operate independently,
or be synchronized to perform conversions at the same time. Conversion completions are indicated by sta-
tus bits, and can generate interrupts. The resulting 16-bit data words are latched into SFRs upon comple-
tion of a conversion. A DMA interface is also provided, which can gather conversions from the ADCs, and
directly store them to on-chip or external RAM.
ADC0 also contains Window Compare registers, which can be configured to interrupt the controller when
ADC0 data is within or outside of a specified range. ADC0 can monitor a key voltage continuously in back-
ground mode, and not interrupt the controller unless the converted data is within the specified window.
16-Bit Analog to Digital Converters
(DC, -0.2 to 0.6 V)
(DC, -0.2 to 0.6 V)
AIN0G
AIN1G
AIN0
AIN1
Figure 1.12. 16-Bit ADC Block Diagram
Configuration and Control
ADC0
ADC1
16-Bit
16-Bit
Registers
SAR
SAR
Start Conversion
Rev. 1.2
Start Conversion
16
16
C8051F060/1/2/3/4/5/6/7
ADC Data
Registers
Write to AD1BUSY
Timer 3 Overflow
CNVSTR1
Timer 2 Overflow
Write to AD0BUSY
Write to AD0BUSY
Timer 3 Overflow
CNVSTR0
Timer 2 Overflow
Interface
Compare
Window
DMA
ADC0
Logic
33