NH82801DB S L8DE Intel, NH82801DB S L8DE Datasheet - Page 460

• Manufacturer Part Number: NH82801DB S L8DE
• Manufacturer: Intel

Specifications of NH82801DB S L8DE

• Lead Free Status / RoHS Status: Compliant

SMBus Controller Registers (D31:F3)
13.2.6
13.2.7
13.2.8
460
HST_D1—Data 1 Register
Register Offset:
Default Value:
Host_BLOCK_DB—Host Block Data Byte Register
Register Offset:
Default Value:
PEC—Packet Error Check (PEC) Register
Register Offset:
Default Value:
Bit
7:0
Bit
7:0
Bit
7:0
DATA1 — R/W. This eight bit register is transmitted in the DATA1 field of the SMBus protocol during
the execution of any command.
Block Data (BDTA) — R/W. This is either a register, or a pointer into a 32-byte block array, depending
upon whether the E32B bit is set in the Auxiliary Control register. When the E32B bit is cleared, this is
a register containing a byte of data to be sent on a block write or read from on a block read, just as it
behaved on the ICH3.
When the E32B bit is set, reads and writes to this register are used to access the 32-byte block data
storage array. An internal index pointer is used to address the array, which is reset to 0 by reading the
HCTL register (offset 02h). The index pointer then increments automatically upon each access to this
register. The transfer of block data into (read) or out of (write) this storage array during an SMBus
transaction always starts at index address 0.
When the E2B bit is set, for writes, software will write up to 32-bytes to this register as part of the
setup for the command. After the Host controller has sent the Address, Command, and Byte Count
fields, it will send the bytes in the SRAM pointed to by this register. After the byte count has been
exhausted, the controller will set the DONE_STS bit (see definition above).
When the E2B bit is cleared for writes, software will place a single byte in this register. After the host
controller has sent the address, command, and byte count fields, it will send the byte in this register. If
there is more data to send, software will write the next series of bytes to the SRAM pointed to by this
register and clear the DONE_STS bit. The controller will then send the next byte. During the time
between the last byte being transmitted to the next byte being transmitted, the controller will insert
wait-states on the interface.
When the E2B bit is set for reads, after receiving the byte count into the Data0 register, the first series
of data bytes go into the SRAM pointed to by this register. If the byte count has been exhausted or the
32-byte SRAM has been filled, the controller will generate an SMI# or interrupt (depending on
configuration) and set the DONE_STS bit. Software will then read the data. During the time between
when the last byte is read from the SRAM to when the DONE_STS bit is cleared, the controller will
insert wait-states on the interface.
PEC_DATA — R/W. This 8-bit register is written with the 8-bit CRC value that is used as the SMBus
PEC data prior to a write transaction. For read transactions, the PEC data is loaded from the SMBus
into this register and is then read by software. Software must ensure that the INUSE_STS bit is
properly maintained to avoid having this field over-written by a write transaction following a read
transaction.
06h
00h
07h
00h
08h
00h
Description
Description
Description
Attribute:
Size:
Attribute:
Size:
Attribute:
Size:
Intel
R/W
8 bits
R/W
8 bits
R/W
8 bits
®
82801DB ICH4 Datasheet