DF2378BVFQ35WV Renesas Electronics America, DF2378BVFQ35WV Datasheet - Page 845

• Manufacturer Part Number: DF2378BVFQ35WV
• Description: IC H8S/2378 MCU FLASH 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2378BVFQ35WV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 35MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 97
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 6x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-QFP
• For Use With: EDK2378 - DEV EVAL KIT FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

16.3.2
ICCRB is an 8-bit readable/writable register that issues start/stop conditions, manipulates the SDA
pin, monitors the SCL pin, and controls reset in I
Bit
7
6
5
4
3
2
Bit Name
BBSY
SCP
SDAO
⎯
SCLO
⎯
I
2
C Bus Control Register B (ICCRB)
Initial Value
0
1
1
1
1
1
R/W
R/W
W
R/W
R/W
R
⎯
Description
Bus Busy
This bit enables to confirm whether the I
occupied or released and to issue start and stop
conditions in master mode. This bit is set to 1 when
the SDA level changes from high to low under the
condition of SCL = high, assuming that the start
condition has been issued. This bit is cleared to 0
when the SDA level changes from low to high
under the condition of SCL = high, assuming that
the stop condition has been issued. Write 1 to
BBSY and 0 to SCP to issue a start condition.
Follow this procedure when also re-transmitting a
start condition. Write 0 to BBSY and 0 to SCP to
issue a stop condition. To issue a start/stop
condition, use the MOV instruction.
Start Condition/Stop Condition Prohibit
The SCP bit controls the issue of start/stop
conditions in master mode.
To issue a start condition, write 1 in BBSY and 0 in
SCP. A retransmit start condition is issued in the
same way. To issue a stop condition, write 0 in
BBSY and 0 in SCP. This bit is always read as 1. If
1 is written, the data is not stored.
Monitors the output level of SDA.
0: When reading, SDA pin outputs low.
1: When reading, SDA pin outputs high.
The write value must always be 1.
Reserved
The write value must always be 1.
This bit monitors SCL output level. When reading
and SCLO is 1, SCL pin outputs high. When
reading and SCLO is 0, SCL pin outputs low.
Reserved
This bit is always read as 1.
2
C control.
Section 16 I
Rev.7.00 Mar. 18, 2009 page 777 of 1136
2
C Bus Interface 2 (IIC2) (Option)
REJ09B0109-0700
2
C bus is