UPD78F0513AMC-GAA-AX Renesas Electronics America, UPD78F0513AMC-GAA-AX Datasheet - Page 130

• Manufacturer Part Number: UPD78F0513AMC-GAA-AX
• Description: MCU 8BIT 38PIN SSOP
• Manufacturer: Renesas Electronics America
• Series: 78K0/Kx2r

Specifications of UPD78F0513AMC-GAA-AX

• Core Processor: 78K/0
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0/Kx2
3.2.3 Special function registers (SFRs)
manipulation instructions. The manipulatable bit units, 1, 8, and 16, depend on the special function register type.
R01UH0008EJ0401 Rev.4.01
Jul 15, 2010
Unlike a general-purpose register, each special function register has a special function.
SFRs are allocated to the FF00H to FFFFH area.
Special function registers can be manipulated like general-purpose registers, using operation, transfer, and bit
Each manipulation bit unit can be specified as follows.
• 1-bit manipulation
• 8-bit manipulation
• 16-bit manipulation
Table 3-8 gives a list of the special function registers. The meanings of items in the table are as follows.
• Symbol
• R/W
• Manipulatable bit units
• After reset
Describe the symbol reserved by the assembler for the 1-bit manipulation instruction operand (sfr.bit).
This manipulation can also be specified with an address.
Describe the symbol reserved by the assembler for the 8-bit manipulation instruction operand (sfr).
This manipulation can also be specified with an address.
Describe the symbol reserved by the assembler for the 16-bit manipulation instruction operand (sfrp).
When specifying an address, describe an even address.
Symbol indicating the address of a special function register. It is a reserved word in the RA78K0, and is defined as
an sfr variable using the #pragma sfr directive in the CC78K0. When using the RA78K0, ID78K0-QB, SM+ for 78K0,
and SM+ for 78K0/KX2, symbols can be written as an instruction operand.
Indicates whether the corresponding special function register can be read or written.
R/W: Read/write enable
R:
W:
Indicates the manipulatable bit unit (1, 8, or 16). “−” indicates a bit unit for which manipulation is not possible.
Indicates each register status upon reset signal generation.
Read only
Write only
CHAPTER 3 CPU ARCHITECTURE
130