SR2400PP Intel, SR2400PP Datasheet - Page 53

• Manufacturer Part Number: SR2400PP
• Manufacturer: Intel

Specifications of SR2400PP

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Intel® Server Board SE7320VP2
3.4.9.2.2
Serial B is an external 8-pin RJ45 connector that is located on the back edge of the baseboard.
For those server applications that require an external modem, an RJ45-to-DB9 adapter is
necessary.
3.4.9.2.3
The rear RJ45 Serial B port is a fully functional serial port that can support any standard serial
device. Using an RJ45 connector for a serial port allows direct support for serial port
concentrators, which typically use RJ45 connectors and are widely used in the high-density
server market. For server applications that use a serial concentrator to access the server
management features of the baseboard, a standard 8-pin CAT-5 cable from the serial
concentrator is plugged directly into the rear RJ45 serial port.
To allow support for either of two serial port configuration standards, a jumper block located
directly behind the rear RJ45 serial port must be configured appropriately according to the
desired standard. For serial concentrators that require a DCD signal, the jumper block must be
configured with the Serial Port jumper and must be over position 1 and 3. For serial
concentrators that require a DSR signal (Default), the jumper block must be configured with the
Serial Port jumper over position 2 and 4. Pin 1 on the jumper is denoted by “*”.
Note: By default, the rear RJ45 serial port is configured to support a DSR signal, which is
compatible with the Cisco* standard.
Revision 2.1
Serial Port B
Rear RJ45 Serial B Port Configuration
Figure 7. Serial Port Configuration Jumper Location
Table 16. Serial Port Configuration Jumper [J8A3]
Intel order number C91056-002
Functional Architecture
53