FDC37C669-MT SMSC, FDC37C669-MT Datasheet - Page 74

• Manufacturer Part Number: FDC37C669-MT
• Description: IC CTRLR SUPER I/O FLPPY 100TQFP
• Manufacturer: SMSC

Specifications of FDC37C669-MT

• Controller Type: I/O Controller
• Interface: ISA Host
• Voltage - Supply: 4.5 V ~ 5.5 V
• Current - Supply: 25mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 638-1008

Bit 2
Setting this bit to a logic "1" clears all bytes in the XMIT
FIFO and resets its counter logic to 0. The shift register
is not cleared. This bit is self-clearing.
Bit 3
Writing to this bit has no effect on the operation of the
UART. The RXRDY and TXRDY pins are not available
on this chip.
Bit 4,5
Reserved
Bit 6,7
These bits are used to set the trigger level for the RCVR
FIFO interrupt.
INTERRUPT IDENTIFICATION REGISTER (IIR)
Address Offset = 2H, DLAB = X, READ
By accessing this register, the host CPU can determine
the highest priority interrupt and its source. Four levels of
priority interrupt exist. They are in descending order of
priority:
1. Receiver Line Status (highest priority)
2. Received Data Ready
Bit 7
0
0
1
1
Bit 6
0
1
0
1
Trigger Level
RCVR FIFO
(BYTES)
14
1
4
8
74
3. Transmitter Holding Register Empty
4. MODEM Status (lowest priority)
Information indicating that a prioritized interrupt is pending
and the source of that interrupt is stored in the Interrupt
Identification Register (refer to Interrupt Control Table).
When the CPU accesses the IIR, the Serial Port freezes
all interrupts and indicates the highest priority pending
interrupt to the CPU. During this CPU access, even if the
Serial Port records new interrupts, the current indication
does not change until access is completed. The contents
of the IIR are described below.
Bit 0
This bit can be used in either a hardwired prioritized or
polled environment to indicate whether an interrupt is
pending. When bit 0 is a logic "0", an interrupt is pending
and the contents of the IIR may be used as a pointer to
the appropriate internal service routine. When bit 0 is a
logic "1", no interrupt is pending.
Bits 1 and 2
These two bits of the IIR are used to identify the highest
priority interrupt pending as indicated by the Interrupt
Control Table.
Bit 3
In non-FIFO mode, this bit is a logic "0". In FIFO mode
this bit is set along with bit 2 when a timeout interrupt is
pending.
Bits 4 and 5
These bits of the IIR are always logic "0".
Bits 6 and 7
These two bits are set when the FIFO CONTROL
Register bit 0 equals 1.