TC58NVG1S3ETA00 Toshiba, TC58NVG1S3ETA00 Datasheet - Page 36

• Manufacturer Part Number: TC58NVG1S3ETA00
• Manufacturer: Toshiba

Specifications of TC58NVG1S3ETA00

• Cell Type: NAND
• Density: 2Gb
• Access Time (max): 30us
• Interface Type: Serial
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: 0C to 70C
• Package Type: TSOP-I
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Asynchronous
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 256M
• Supply Current: 30mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Supplier Unconfirmed

RY/
The column address can be changed by the 85h command during the data input sequence of the Auto Page Program
operation.
Two address input cycles after the 85h command are recognized as a new column address for the data input. After
the new data is input to the new column address, the 10h command initiates the actual data program into the
selected page automatically. The Random Column Address Change operation can be repeated multiple times within
the same page.
CLE
ALE
RE
BY
WE
I/O
CE
80h
Auto Page Program Operation
after the address and data have been input. The sequence of command, address and data input is shown below.
(Refer to the detailed timing chart.)
Random Column Address Change in Auto Page Program Operation
Data input
The device carries out an Automatic Page Program operation when it receives a "10h" Program command
80h
Col. M
Selected
page
Col. M
Program
Data input
Selected
Page N
page
Page P
Din
Col. M
Read& verification
Din
Program
Din
Din
Din Din
Data
Col. M’
Din
Reading & verification
the Page Buffer to the selected page on the rising edge of WE
following input of the “10h” command. After programming, the
programmed data is transferred back to the Page Buffer to be
automatically verified by the device. If the programming does not
succeed, the Program/Verify operation is repeated by the device
until success is achieved or until the maximum loop number set in
the device is reached.
85h
Din
The data is transferred (programmed) from the Data Cache via
36
10h
Col. M’
Din
Din
Din
TC58NVG1S3ETA00
Din
70h
10h
Status
Out
Busy
2010-05-21C
70h
Status