TC58NVG1S3ETA00 Toshiba, TC58NVG1S3ETA00 Datasheet - Page 51

• Manufacturer Part Number: TC58NVG1S3ETA00
• Manufacturer: Toshiba

Specifications of TC58NVG1S3ETA00

• Cell Type: NAND
• Density: 2Gb
• Access Time (max): 30us
• Interface Type: Serial
• Boot Type: Not Required
• Address Bus: 1b
• Operating Supply Voltage (typ): 3.3V
• Operating Temp Range: 0C to 70C
• Package Type: TSOP-I
• Program/erase Volt (typ): 2.7 to 3.6V
• Sync/async: Asynchronous
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8b
• Number Of Words: 256M
• Supply Current: 30mA
• Mounting: Surface Mount
• Pin Count: 48
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Chip Status 1:
Chip Status 2:
Status Read
The Status Read function is used to monitor the Ready/Busy status of the device, determine the result (pass
/fail) of a Program or Erase operation, and determine whether the device is in Protect mode. The device status is
output via the I/O port using RE after a “70h” command input. The Status Read can also be used during a
Read operation to find out the Ready/Busy status.
Table 6. Status output table
I/O1
I/O2
I/O3
I/O4
I/O5
I/O6
I/O7
I/O8
The Pass/Fail status on I/O1 and I/O2 is only valid during a Program/Erase operation when the device is in the Ready state.
The device automatically implements the execution and verification of the Program and Erase operations.
The resulting information is outlined in Table 6.
current page program operation, and therefore this bit is only valid when I/O6 shows the Ready state.
with Data Cache. This status is valid when I/O7 shows the Ready State.
15h or 31h.
During a Auto Page Program or Auto Block Erase operation this bit indicates the pass/fail result.
During a Auto Page Programming with Data Cache operation, this bit shows the pass/fail results of the
This bit shows the pass/fail result of the previous page program operation during Auto Page Programming
The status output on the I/O6 is the same as that of I/O7 if the command input just before the 70h is not
Chip Status1
Pass: 0
Chip Status 2
Pass: 0
Not Used
Not Used
Not Used
Page Buffer Ready/Busy
Ready: 1
Data Cache Ready/Busy
Ready: 1
Write Protect
Not Protected :1
Definition
Fail: 1
Fail: 1
Protected: 0
Busy: 0
Busy: 0
Pass/Fail
Invalid
0
0
0
Ready/Busy
Ready/Busy
Write Protect
Page Program
Block Erase
51
Pass/Fail
Pass/Fail
0
0
0
Ready/Busy
Ready/Busy
Write Protect
Cache Program
TC58NVG1S3ETA00
Invalid
Invalid
0
0
0
Ready/Busy
Ready/Busy
Write Protect
Cache Read
2010-05-21C
Read