ATmega406 Atmel Corporation, ATmega406 Datasheet - Page 192

• Manufacturer Part Number: ATmega406
• Manufacturer: Atmel Corporation

Specifications of ATmega406

• Flash (kbytes): 40 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 1 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 8
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 18
• Ext Interrupts: 4
• Usb Speed: No
• Usb Interface: No
• Twi (i2c): 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1.9
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 2
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -30 to 85
• I/o Supply Class: 4.0 to 25
• Operating Voltage (vcc): 4.0 to 25
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 3
• Pwm Channels: 2
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

192
ATmega406
Rdloop:
Return:
Do_spm:
Wait_spm:
Wait_ee:
ldi
call Do_spm
; read back and check, optional
ldi
ldi
subi YL, low(PAGESIZEB)
sbci YH, high(PAGESIZEB)
lpm
ld
cpse r0, r1
jmp
sbiw loophi:looplo, 1
brne Rdloop
; return to RWW section
; verify that RWW section is safe to read
in
sbrs temp1, RWWSB
ret
; re-enable the RWW section
ldi
call Do_spm
rjmp Return
; check for previous SPM complete
in
sbrc temp1, SPMEN
rjmp Wait_spm
; input: spmcrval determines SPM action
; disable interrupts if enabled, store status
in
cli
; check that no EEPROM write access is present
sbic EECR, EEWE
rjmp Wait_ee
; SPM timed sequence
out
spm
; restore SREG (to enable interrupts if originally enabled)
out
ret
spmcrval, (1<<RWWSRE) | (1<<SPMEN)
looplo, low(PAGESIZEB)
loophi, high(PAGESIZEB)
r0, Z+
r1, Y+
Error
temp1, SPMCSR
spmcrval, (1<<RWWSRE) | (1<<SPMEN)
temp1, SPMCSR
temp2, SREG
SPMCSR, spmcrval
SREG, temp2
; If RWWSB is set, the RWW section is not ready yet
;init loop variable
;not required for PAGESIZEB<=256
;restore pointer
;use subi for PAGESIZEB<=256
2548E–AVR–07/06